Altair 52563-BAT-WH-FB Maintenance Instruction

Maintenance & Instructions
Please retain this manual after installation for future reference and
maintenance
Product must be installed in compliance with relevant Water Bylaws
IMPORTANT:
* Two people are required for installation.
* Freestanding tub is not designed to take weight on the rim.
Do not sit or stand on the tub rim.
Receive Your Tub
A) Unpack and check for damage.
After receiving your tub, please unpack and remove all covering, checking whether there is
any damage. Repack the tub if it is not being immediately installed. It will be rejected any
claim for damage if not notified in a timely manner.
52563-BAT-WH-FB
Altair Inc.
B) Protect your Tub.
Before commencing and installation, ensure the Tub is completely protected, leave covering
in place until the bathroom is complete. Scratches and damage incurred during installation
are not covered by the warranty.
TOOLS REQUIRED FOR INSTALLATION
Spirit Level Wrench
Step 1
Adjust the tub feet until the tub base is 3mm above the floor;
This can be done by turning the feet bars accordingly;
Then use wrench to tighten the nuts on the bars.
See figure 1
Figure 1
Feet set at 3mm above the floor
Step 2
Mark the floor with the outline of the tub, at the final installation position with the marking
pencil.
51167-BAT-WH-FB
Tape Marking Pencil Silicone Gun