Frigidaire FFTR1614TW Use & Care Manual page 20

CARE & CLEANING
Part What To Use
Interior & • Soap and water
Door Liners
• Baking soda and
water
Door • Soap and water
Gaskets
Drawers & • Soap and water
Bins
Glass • Soap and water
Shelves
• Glass cleaner
• Mild liquid sprays
Toe Grille • Soap and water
• Mild liquid sprays
• Vacuum attachment
Exterior & • Soap and water
Handles
• Non Abrasive Glass
Cleaner
Exterior & • Soap and water
Handles
• Stainless Steel
Cleaners
(Stainless
Steel
Models
Only)
Replacing • Unplug refrigerator
Light Bulbs
• Wear gloves
• Remove light cover
(some models)
• Replace old bulb
• Replace light cover
(some models)
• Plug in the
refrigerator
20
Care & Cleaning Tips
Tips and Precautions
Use 2 tablespoons of baking soda in 1 quart of warm
water. Be sure to wring excess water out of sponge
or cloth before cleaning around controls, light bulb
or any electrical part.
Wipe gaskets with a clean soft cloth.
Use a soft cloth to clean drawer runners and tracks.
Allow glass to warm to room temperature before
immersing in warm water.
Vacuum dust from front of toe grille. Remove
toe grille (see Installation Instructions). Vacuum
backside, wipe with sudsy cloth or sponge. Rinse
and dry.
Do not use commercial household cleaners
containing ammonia, bleach or alcohol to clean
handles. Use a soft cloth to clean smooth handles.
DO NOT use a dry cloth to clean smooth doors.
Never use CHLORIDE or cleaners with bleach to
clean stainless steel.
Clean stainless steel front and handles with non-
abrasive soapy water and a dishcloth. Rinse with
clean water and a soft cloth. Use a non-abrasive
stainless steel cleaner. These cleaners can be
purchased at most home improvement or major
department stores. Always follow manufacturer's
instructions. Do not use household cleaners
containing ammonia or bleach.
NOTE: Always clean, wipe and dry with the grain
to prevent scratching. Wash the rest of the cabinet
with warm water and mild liquid detergent. Rinse
well, and wipe dry with a clean soft cloth.
CAUTION: Wear gloves when replacing light bulbs
to avoid getting cut. Use same wattage when
replacing bulb