ONvocal MIX360 Quick Start Manual

MIX360
QUICK START GUIDE
™
DOWNLOAD
For the best Mix360 experience, download the free
ONvocal app, available for iPhone and Android.
WEAR
1. Place earbuds on magnetic stays at neckband ends.
2. For a more secure fit, bend neckband smaller than
your neck size using the Flex Zones before wearing.
• Bend only in the Flex Zone areas to prevent damage.
3. Put neckband on. One at a time, drape ear bud
wires over each ear and squeeze foam tips before
inserting, allowing foam to expand for optimal
performance and sound isolation.
4. Slide wire cinch up or down to conceal excess wire.
5. Adjust microphone boom so it points toward the
corner of your mouth.
OnVocal-QuickStartGuide-E.6.2.indd 1
™ ™
COMMAND
FLEX ZONE
AREA
FLEX ZONE
AREA
LED
AUDIO UP
AUDIO DOWN
PLAY/PAUSE
MAGNETIC
STAY
LINE INPUT
Visit our support site for more
detailed instructions, FAQs and
videos on using the Mix360.
PAIR
1. Press and hold Power button to turn on the Mix360.
2. Enable pairing on your Bluetooth-enabled device.
3. Select "ONvocal" from the list of available devices.
WIRE CINCH
CONTROL
Adjust Music Playback, Volume, Ambient and Voice
FLEX ZONE
levels using buttons on the neckband.
AREA
• Briefly press Ambient or Voice buttons to
• Press and hold Ambient or Voice buttons
• Press Command button to answer/end calls or
POWER
• Double press Play/Pause button to skip audio
VOICE
AMBIENT
MAGNETIC
Use the free ONvocal app for finer adjustments of
STAY
MICRO-USB
Audio, Ambient, and Voice levels for music and phone
CHARGING PORT
calls alike. Save your favorite settings as presets.
*LED is red while charging and
turns white when fully charged.
ONvocal.com/support
• The LED flashes red and white to
indicate pairing mode is active.
• If a PIN is requested, use "0000".
enable or disable.
to cycle through volume levels.
activate your phone's voice command app.
tracks while playing music; single press during
a call to mute or un-mute the mic.
1/13/16 3:46 PM