SANFORD TOOLS LM172 Instructions

Instruction for wireless keypad
1. Code Learn
The keypad must be entry to the receiver before use.
Press the LEARN switch on receiver, the LED on
receiver light on.
Press the "*" key on keypad, follow by the six
passwords, then the "#" key. The LED on receiver will flash
2 second. Then the keypad can be used, the press key as the
password.
For example, press * 1 2 3 4 5 6 #, the password is
123456.
The alternation of two inputs must less 1s. if not, the
input is interrupt, and must input again.
2. Entry via Keypad
Press the "*" key, followed by the six passwords, then
the entry key (the largest at bottom), the receiver get the
password. If the passwords are correct, the receiver's relay
active.
For example, press * 1 2 3 4 5 6, ENTRY, the relay
work.