Advertisement

Quick Links

INSTALLATION INSTRUCTIONS
FOR
MODEL ALS-218
www.allstarscoreboards.com
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ALS-218 and is the answer not in the manual?

Questions and answers

Summary of Contents for All-Star Scoreboards ALS-218

  • Page 1 INSTALLATION INSTRUCTIONS MODEL ALS-218 www.allstarscoreboards.com...
  • Page 2: Table Of Contents

    Table of Contents MODEL ALS-218LED ............................. 3 8’ X 2’ INDOOR SCOREBOARD .......................... 3 THE SCOREBOARD SYSTEM SHOULD INCLUDE THE FOLLOWING PARTS: ......3 PRODUCT SPECIFICATIONS ..........................4 Overall Dimensions: ............................4 Weight: ..................................4 Power Requirements: ............................4 Communication Cable Requirements (for cable-controlled systems only): ......5 MOUNTING THE SCOREBOARD TO A WALL ....................
  • Page 3: Model Als-218Led

    MODEL ALS-218LED 8’ X 2’ INDOOR SCOREBOARD NOTE TO INSTALLERS: PLEASE RETURN THIS MANUAL TO THE INDIVIDUAL IN CHARGE OF THE SCOREBOARD UPON COMPLETION OF INSTALLATION. The scoreboard and all accompanying accessories have been carefully inspected and tested before leaving the factory. However, it is possible for damage to have occurred during shipping.
  • Page 4: Product Specifications

    If damage is discovered after delivery, call the delivery company to report the concealed damage and please call the manufacturer immediately to report. Concealed damage must be reported within 5 days after the delivery date. If the damages are found after this time, the manufacturer will not be responsible.
  • Page 5: Communication Cable Requirements (For Cable-Controlled Systems Only)

    Keyboard controller: • 1 - 120-volt, 15-amp, 60 Hz grounded AC circuit - standard wall receptacle. Communication Cable Requirements (for cable-controlled systems only): Four conductor cable – 28 gauge, twisted pair (two pairs), shielded data cable. MOUNTING THE SCOREBOARD TO A WALL NOTE: Use hardware appropriate for the wall type you are mounting to and capable of supporting the weight of the scoreboard.
  • Page 6: Hanging The Scoreboard From The Ceiling

    HANGING THE SCOREBOARD FROM THE CEILING 1. Remove the scoreboard from its packaging, making sure not to pry against or cut into the scoreboard. Inspect the unit for shipping damage according to the instructions on page 1. NOTE: CARE MUST BE TAKEN NOT TO DAMAGE THE SCOREBOARD WHILE LIFTING IT INTO PLACE. IF THE SCOREBOARD WILL BE “AGAINST”...
  • Page 7: Running & Connecting The Control Cable

    RUNNING & CONNECTING THE CONTROL CABLE (For scoreboards with Wireless Remote Control, skip this step.) The control cable must be run in a separate conduit than is used for the electrical service. The control cable should run from the scoreboard to a location that is within 10 feet of the scorekeeper’s location and into a 2”X4”...
  • Page 8: Running & Connecting The Electric Service

    1. Inside the scoreboard, connect the control cable leads to the appropriate terminals on the terminal block, according to the label above the terminal block. 3. Close and secure the module access door. RUNNING & CONNECTING THE ELECTRIC SERVICE 1. The scoreboard has a ½” knock-out on the top left corner for bringing in the electrical service. It can be enlarged if the conduit size is ¾”.
  • Page 9: Important Shot Clock Installation Note

    3. Remove the cover on the utility box and route the power supply wiring to the utility box. 4. The connections are standard black, white, and green (ground). Included is a utility ground which must be used. Make up the power supply connections and replace the utility box cover. 5.
  • Page 10 If your scoreboard is a wireless system, verify that the radio transmitter interface cable is connected to both the transmitter and also one of the DIN sockets on the back of the controller. • The HOME and GUEST scores should display a “0” and the PERIOD should show a “1”. •...
  • Page 11: Warranty Activation/Installation & Completion Sign Off Sheet

    IMPORTANT! Warranty Activation/Installation & Completion Sign Off Sheet NOTE: This sheet must be completely filled out and returned/faxed (270) 753-3773 to Scoreboard Service Company before your warranty can be activated. Your Serial Number _______________________________________ Your Model Number _______________________________________ Date Purchased _______________________________________ Sales Agent _______________________________________...

Table of Contents