Maintenance
□
To maintain the beauty of the furniture finish, avoid placing the vanity in direct sunlight.
□
Avoid exposing the vanity combo to extreme temperatures by installing away from heat and air vents.
Care and Cleaning
Countertop Care
□
Rinse Vanity top with clean, hot water when needed.
□
Blot spills quickly, and wash with mild soap and warm water.
□
Remove oil or other difficult stains with Oil Based Sealer. If still can't work, please ask for professional help.
□
If clean with chemical, must re-seal the top (after top completely dry) 1-2 times, and apply clear stone wax for
daily protection.
□
Larger scratches, chips, and resilient stains may require professional help. Please contact your local stonemason
for details.
□
Your vanity top was sealed at the factory, but reapplication is necessary over time. How often is determined by
the quality of the sealer used, and the frequency of use. We recommend using a penetrating non-toxic sealer for
best results.
Cabinet Care
□
Dust the vanity frequently with a clean, soft, dry, lint-free cloth, as well as polish it on a regular basis.
□
Clean up excess water and spills immediately. Use a blotting rather than a wiping action. Water left over for a long
period of time will cause white spots in the finish.
□
Clean the surface by rubbing in the direction of the grain. Use furniture cleaners or polishes recommended by
your local hardware store, following manufacturer's application and cleaning instructions. Avoid using silicone
cleaners and waxes.
Troubleshooting
Problem
Vanity doors rub against another
surface.
There is an uneven gap between the
doors and cabinet.
Possible Cause
The floor is not level.
The floor is not level.
7
Corrective Action
1. Adjust the leg levelers to ensure the vanity
combo is level.
2.
Adjust the door hinges.
1. Adjust the leg levelers to ensure the vanity
combo is level.
2.
Adjust the door hinges.
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-998-7021 for further assistance.
Need help?
Do you have a question about the WINDLOWE 15101-VS49C-AT and is the answer not in the manual?