Table of Contents
Advertisement
Pull out the condensate container
6.
fully.
Turn the condensate container by
7.
180° onto its underside and release
the stopper which is fitted there. Turn
the container back by 180° and
press the stopper into the opening
on the upper side of the condensate
container.
Pull the filter out of the notch and
8.
place it into the recess on the
condensate container.
Push in the condensate container
9.
until it locks into place.
The condensation is now discharged via
the drain hose into the waste-water
system or into a wash basin
If you want to change the
Note:
condensation drain back to the
condensate container, carry out these
steps in reverse order.
Installation and connection
Optional accessories
Order optional accessories* from the
after-sales service:
Washer/dryer stack connection set:
■
To save space, the dryer can be
placed on top of a suitable washing
machine of the same width and
depth.
The dryer must be fastened to the
washing machine using this
connection set.
Order number, pull-out worktop
included: WTZ11400;
Order number, pull-out worktop not
included: WTZ20410.
Platform:
■
For easier loading and unloading,
raise your dryer with a platform.
Transport laundry with the clothes
basket integrated into the platform
drawer.
Order number: WMZ20500.
* depending on the model
Transport and frost protection
Empty the condensate container and
residual water from the dryer:
Select any programme using the
1.
programme selector.
Press the Start button.
2.
Wait for 5 minutes.
3.
The condensation is drained.
Note:
Empty the condensate container
4.
again.
Switch off the dryer.
5.
Caution!
Any residual water may leak out and
cause material damage.
Transport the dryer in an upright
position.
Caution!
The dryer contains coolant and may be
damaged.
Allow the dryer to rest for two hours
before initial use.
en
31
Advertisement
Table of Contents
