Advertisement
Quick Links
Advertisement
Summary of Contents for Padom SH-02
- Page 1 Padom Sunrise Alarm Clock User Manual (EN)
- Page 2 To reduce the risk of Fire, Electric Shock, or Injury to Persons: This appliance is only intended for household use, including similar use in hotels. Place this appliance on a stable, level and non-slippery surface. Do not use this appliance in wet surroundings (e.g. in the bathroom or near a shower or swimming pool).
- Page 3 Clean the appliance with a soft cloth. Do not use abrasive cleaning agents, pads or cleaning solvents like alcohol, acetone, etc., as this might damage the surface of the appliance. lf the appliance will not be used for an extended period of time, remove the power cord from the wall outlet and store the appliance in a safe, dry surroundings where it will not be crushed, banged, or subject to...
- Page 4 You have to set the clock time when you plug in the appliance for the first time. 1. Hold the setting button (in the lower right corner) for 2 seconds to enter the time setting mode. 2. Click+/- button (in the upper left corner) to select "Hour". For example, "6".
- Page 5 1. Press the alarm 1 button to turn the alarm 1 on. Hope the alarm 1 button for 2 seconds to enter the alarm 1 setting mode. 2. Press+/- button to adjust "Hour". For example, "6". Press the alarm 1 button to confirm it. 3.
- Page 6 You have set up the alarm The sunrise light will be on gradually from 10% brightness to 100% by 10 minutes from 6:20 10 minutes later, the alarm will go off at 6:30 You can get an extra 9 minutes of sleep time after pressing the snooze button (snooze up to 5 times).
- Page 7 5. Press the LED light button again to quit the colorful light mode.
- Page 8 1. Hold the radio button down for 2 seconds, the clock will scan all the available stations automatically and save them as P-01/P-02/P-03 and so on (up to 10 channels). You don't need to do anything until it finishes the process.
- Page 9 Press ode. Hold the fall-asleep button for 2 seconds to set the fall-asleep mode. Press the + / - button to adjust the Timer (up to 120 minutes). And then press the fall-asleep button to confirm it. Press the + / - button to adjust the Brightness. And then press the fall-asleep button to confirm it.
- Page 10 Please Note: After finish setting, the light will slowly turn on from the pre-set brightness level to dark, and the light will turn off at the end of the preset time. Specifications Material: PC, ABS, Electronics Size: 170×170×55 mm Weight: 350g Battery: Built-in 210mAh Battery FM Frequency: 78–108 MHz Light Brightness function: 20 levels light brightness...
- Page 11 Q 1: This appliance doesn't work at all. 1. Perhaps the adapter is not inserted properly in the walloutlet. Plug the adapter properly in the wall outlet. 2. Perhaps there is a power failure. Check if the power supply works by connecting another appliance. Q 2: The radio products a cracking sound.
- Page 12 Q 5: How can I turn the alarm sound off once it has gone off? 1. You just need to press the corresponding alarm button. So if you set "Alarm 1" press the "Alarm 1" button on the side and it should shut off.