Biostar A620MP-E PRO Manual page 27

BIOSTAR BIO-Flasher
Note
» » This utility only allows storage device with FAT32/16 format and single partition.
» » Shutting down or resetting the system while updating the BIOS will lead to system boot failure.
Updating BIOS with BIOSTAR BIOS Flasher
1. Go to the website to download the latest BIOS file for the motherboard.
2. Then, copy and save the BIOS file into a USB flash (pen) drive.(Only supported FAT/FAT32
format)
3. Insert the USB pen drive that contains the BIOS file to the USB port.
4. Power on or reset the computer and then press <F12> during the POST process.
5. After entering the POST screen, the BIOS-
FLASHER utility pops out. Choose <fs0> to search
for the BIOS file.
6. Select the proper BIOS file, and a message asking
if you are sure to flash the BIOS file. Click "Yes" to
start updating BIOS.
7. A dialog pops out after BIOS flash is completed,
asking you to restart the system. Press the <Y>
key to restart system.
8. While the system boots up and the full screen logo shows up, press <DEL> key to enter BIOS
setup.
After entering the BIOS setup, please go to the <Save & Exit>, using the <Restore Defaults>
function to load Optimized Defaults, and select <Save Changes and Reset> to restart the
computer. Then the BIOS Update is completed.
A620MP-E PRO
Chapter 3: UEFI BIOS & Software | 27