Table of Contents
Advertisement
ASLE-140-36D
Remote Operation
The ASLE-140-36D can be controlled remotely using a USB, RS-232, or RS422/RS485
interface.
Setup Procedures
ㆍ Press the [Utility] key on the front panel and select one of USB, RS-232, or
RS422/RS485.
ㆍ Connect the ASLE-140-36D to a PC or Server using a communication cable..
☞ Pin-out for RS-232 connector on the rear panel.
Pin number
2
3
5
☞ Pin-out for RS-422/485 connector on the rear panel.
Pin number
3
8
2
7
5
ㆍ Set communication protocol of the PC or Server as follows.
Baud rate : 115200
Data : 8bit
Parity : none
Stop : 1bit
Flow control : none
ㆍ Type "help" to see the control commands of the ASLE-140-36D as shown in
[Figure 4-32].
Signal
TXD
RXD
GND
Signal
TXD+
TXD-
RXD+
RXD-
GND
Copyright © 2022 Polaris. All Rights Reserved
Connector type
D-Sub 9 pin plug connector
Connector type
D-Sub 9 pin plug connector
User Manual
28
Advertisement
Table of Contents
