Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Lazerbuilt PhoneLog Summit
- Page 1 PhoneLog Summit Model Full-Duplex Conference Phone User Guide...
-
Page 2: Important Safety Instructions
Important Safety Instructions Please take a little time to read and understand the information and instructions contained in this user guide. If having read this guide, you require further help or information, please contact the helpline on the telephone number shown in this guide and under the base of your product. Read and understand all instructions. - Page 3 Introduction Your 'Summit' Conference Phone uses digital technology to provide excellent handsfree audio quality and simplicity of use. It includes the following features. Full Duplex Operation Unlike many speakerphones which allow only one party to talk at any one time (simplex operation), the Summit allows all parties to talk and listen at the same time (duplex operation).
-
Page 4: Product Features
Product Features Internal Microphone : Used for talking into the conference phone. For best results, it is recommended that you speak in front of the microphone no farther than 8 to 10 feet away. Speaker : For best results, do not cover with an object of any kind, (including your hand). - Page 5 Product Features Recall Key : Generates a recall signal, required by a PABX to put a call on hold, or when activating additional network services such as call waiting. Mute Button: Disconnects the microphone for private conversations. Mute Indicator Light : Indicates that the unit is in a Mute mode. ON/OFF Button : Turns the conference phone ON or OFF.
-
Page 6: Choosing A Location
Installation Choosing a Location To Connect the Conference Phone For best results, please note the following :- Even thought the Summit conference phone has a built-in Everyone who is speaking dialler, we recommend that it be should be no further than connected in parallel with an 8 to 10 feet from the ordinary telephone. -
Page 7: Installation
Installation Setting the Pulse / Tone Pulse position and try the test above again. switch. Before you can dial a call on the Using the Tone Button Summit conference phone, you If you have set the Tone / Pulse must select which form of dialling switch to the Pulse position, you it will use. -
Page 8: Operation
Operation to include a non active party in Making a Call Using the your call i.e. you would like Summit Conference another partly to listen in to a Phone conversation or discussion you 1 Press the ON/OFF button and are having, but not be able to listen for dial tone. -
Page 9: Ringer Equivalence Number (Ren)
Operation Making a Call using a Recall The Summit conference phone Parallel Telephone generates a recall signal for use You can also make a call on a when connected to an office parallel (extension) telephone PABX (transferring or placing and then transfer the call to the calls on hold etc.) or when Summit conference phone. - Page 10 Extension Microphone (Option) base unit may result in Using the optional interference. Extension Microphone It is installed by plugging the The optional Extension connector plug into the socket Microphone will increase the provided at the rear of the base area over which people taking unit.
-
Page 11: General Information
General Information Care and Maintenance The following suggestions will help you care for this product. Keep the unit dry. If it gets wet, wipe it dry immediately. Liquids may contain minerals that can corrode electronic parts. Use and store the conference phone in normal temperature environments. -
Page 12: Troubleshooting
Troubleshooting Helpline If the actions suggested in this troubleshooting section do not resolve your problems. Please call the telephone helpline (during office hours) on the following UK number. Telephone Helpline 01438 749009 The Indicator Lights do not light Make sure the unit is connected to the mains wall outlet and the mains supply is switched ON. - Page 13 Troubleshooting The conference unit does not ring. Check that the Ringer Volume switch is not in the OFF position. Make sure the unit is correctly connected to the telephone wall socket and the mains outlet. If connected as an extension to a PABX, ensure that the PABX will support simple telephone operation.
- Page 14 If it becomes faulty within the guarantee period but after the first month, it should be returned for repair to Lazerbuilt (at the address shown above), either directly or via your retailer.
- Page 15 10 days of purchase to :- Lazerbuilt Ltd 20 Gunnels Wood Park Stevenage Herts, SG1 2BH If your guarantee is not registered, Lazerbuilt will require proof of purchase before carrying out any in-guarantee repairs. Please retain your purchase receipt.