Advertisement
Installation Guide for Turbo Blower
NX/NC Turbo blower series
This manual provides safe and reliable instructions for the installation of Neuros turbo blower.
Carefully read this manual before attempting installation. If you are uncertain about any of
the instructions or procedure provided in the manual, contact Neuros or Distributor.
Ver.1.0
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Neuros NX Series
- Page 1 Installation Guide for Turbo Blower NX/NC Turbo blower series This manual provides safe and reliable instructions for the installation of Neuros turbo blower. Carefully read this manual before attempting installation. If you are uncertain about any of the instructions or procedure provided in the manual, contact Neuros or Distributor.
- Page 2 Contents Location Selection ……..……………………….………………………………..1 Lifting & Transportation ..……………………………………………………..5 Ver.1.0...
- Page 3 Location Selection ■ Install the blower to a firm and level foundation (such as a concrete floor). (Recommended foundation : more than 100mm) For maintenance perspective, both of the distance between each blower and between blower and wall of blower room has to be 1500mm at least. 100mm ■...
- Page 4 Lifting & Transportation ■ According to installation place, use a forklift or a hoist. Select and use a proper sling belt or ropes depend on gross weight of blower. ■ In case use a forklift, forks have to pass through blower enclosure like fig. 2 to prevent blower from Fig.1 falling to the ground due to wrong use of the forklift.
- Page 5 Lifting & Transportation Eye Bolt Type ■ Lift up and transport the blower with hooking ropes over eye-bolts. ■ There are 4 pcs of eye-bolts on the corners of top section in order to lift up the blower. Be careful not to deform eye-bolts and make the blower fall to the ground due to wrong use of eye-bolts.
- Page 6 Lifting & Transportation No Eye Bolt Type ■ Lift up and transport the blower with ropes or sling belts. Sling Belt ■ When you lift up the blower by hooking ropes or sling Hook belt to crane or hoist, the angle (α) should not exceed Ropes or 90 degree.
Need help?
Do you have a question about the NX Series and is the answer not in the manual?
Questions and answers
have supplier for malaysia