CANARMNA LUL-14 Manual

Questions or Concerns Contact At The Following Phone Numbers Before
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY
!
SAVE THESE INSTRUCTIONS
CAUTIONS:
1. Installation, Operating and Safety Instructions - Instructions for installation and use of this
product are provided by the manufacturer.
by 12 inches".
3. For under cabinet or shelf mount only.
maximum 6 pucks linkable
(additional pucks sold separately)

Surface Mount Installation

Step 1
Using hands, separate outer shell from LED Iamp.
Step 2
Using included hardware and a screw driver,
secure outer shell to cabinet surface.
Step 3
Feed connecting cord through a pre-drilled hole in the cabinet surface
or through the cut-out of the outer shell. Secure LED lamp into outer shell.
LED PUCK LIGHT
Returning Product To The Store:
1-800-265-1833 (English) / 1-800-567-2513 (French)
Monday through Friday 8:00 AM to 5:00 PM E.S.T.
TO PERSONS READ ALL INSTRUCTIONS
IMPORTANT SAFETY
INSTRUCTIONS

TOOLS AND MATERIALS REQUIRED:

Phillips
Wire Cutters
Screwdriver
Pliers
1. Tur
wire.
2. Wire Hardwire box to house electrical supply
wire with strain relief supplied with hardwire
box.
3. Plug driver into hardwire box.
4. Plug power block into supply wire from driver.
5. Plug LED puck light into power block.
6. Make sure all wires are secured correctly.

Plug in install

For hardwire box wire diagram please see page 2

Hardwire install

Recessed Installation

Step 1
Using hands, separate outer shell from LED lamp.
Step 2
Cut out from the bottom of the cabinet a hole
using a 2.5"hole saw.
Step 3
Feed connecting cord through the hole in
cabinet and secure LED lamp.
06/20
LUL-14
Wiring supplies
as required by
local electrical
code
Wrench
power to house electrical supply
Page 1 of 2