Subscribe to Our Youtube Channel
Related Manuals for Crestron CEN-WAP-ABG
Summary of Contents for Crestron CEN-WAP-ABG
- Page 1 Crestron CEN-WAP-ABG 802.11a/b/g Wireless Access Points Operations & Installation Guide...
- Page 2 This document was prepared and written by the Technical Documentation department at: Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 1-888-CRESTRON All brand names, product names and trademarks are the property of their respective owners. ©2009 Crestron Electronics, Inc.
-
Page 3: Table Of Contents
Crestron CEN-WAP-ABG 802.11a/b/g Wireless Access Points Contents 802.11a/b/g Wireless Access Points: CEN-WAP-ABG Introduction ..........................1 Features and Functions ....................1 Specifications ......................3 Physical Description....................5 Industry Compliance ....................10 Setup ............................11 Network Wiring......................11 Supplied Hardware ....................11 Installation ......................... -
Page 5: 802.11A/B/G Wireless Access Points: Cen-Wap-Abg
Crestron CEN-WAP-ABG 802.11a/b/g Wireless Access Points 802.11a/b/g Wireless Access Points: CEN-WAP-ABG Introduction NOTE: Unless otherwise noted, references in this manual to CEN-WAP-ABG apply to both the CEN-WAP-ABG-1G and CEN-WAP-ABG-CM wireless access points. CEN-WAP-ABG wireless access points enable wireless communication for ®... - Page 6 Enterprise Level Security For a secure wireless network in the home or office, a CEN-WAP-ABG supports up to 152-bit WEP encryption as well as more advanced WPA and WPA2 authentication and encryption methods. RADIUS certificates are also supported for a true enterprise level solution.
-
Page 7: Specifications
802.11a/b/g Wireless Access Points Bridge Mode This useful feature allows a CEN-WAP-ABG to be used to add wireless connectivity to any device with an Ethernet port, or to extend a LAN via a wireless link whenever a CAT5 wire cannot be run. - Page 8 * Middle Atlantic HBL1-722243 or equivalent rack mount panel recommended. Note unit dimensions when specifying any other rack mount kit. NOTE: Crestron software and any files on the website are for authorized Crestron dealers and Crestron Authorized Independent Programmers (CAIP) only. New users may be required to register to obtain access to certain areas of the site (including the FTP site).
-
Page 9: Physical Description
CEN-WAP-ABG-1G Physical View (Front and Rear) CEN-WAP-ABG-1G Overall Dimensions (Front View) 2.60 in (6.60 cm) 2.84 in (7.20 cm) 4.14 in (10.51 cm) 1.29 in (3.28 cm) 1.74 in (4.40 cm) 802.11a/b/g Wireless Access Points: CEN-WAP-ABG • 5 Operations & Installation Guide – DOC. 6695C... - Page 10 802.11a/b/g Wireless Access Points Crestron CEN-WAP-ABG CEN-WAP-ABG-1G Overall Dimensions (Side View without Antenna, Left) 0.10 in (0.24 cm) 2.16 in (5.47 cm) 0.30 in (0.77 cm) 0.61 in (1.55 cm) CEN-WAP-ABG-1G Overall Dimensions (Side View with Antenna, Left) 6.21 in (15.75 cm)
- Page 11 Crestron CEN-WAP-ABG 802.11a/b/g Wireless Access Points CEN-WAP-ABG-1G Connectors, Controls & Indicators (Front and Rear) Connectors, Controls & Indicators CONNECTORS, DESCRIPTION CONTROLS & INDICATORS Antenna (1) Connects to supplied antenna. (1) Green LED: Solid green indicates link status of the rear Ethernet port;...
- Page 12 CEN-WAP-ABG-CM Overall Dimensions (Bottom View) 0.80 in (1.93 cm) 1.80 in (4.50 cm) 1.60 in (4.05 cm) CEN-WAP-ABG-CM Overall Dimensions (Side View, Right) 2.80 in (7.05 cm) 8 • 802.11a/b/g Wireless Access Points: CEN-WAP-ABG Operations & Installation Guide – DOC. 6695C...
- Page 13 Crestron CEN-WAP-ABG 802.11a/b/g Wireless Access Points CEN-WAP-ABG-CM Connectors, Control & Indicators (Front and Rear) Connectors, Control & Indicators CONNECTORS, DESCRIPTION CONTROL & INDICATORS (1) Green LED: Solid green indicates link status of the Ethernet port; Flashing green indicates Ethernet activity through the Ethernet port.
-
Page 14: Industry Compliance
This product is Listed to applicable UL Standards and requirements by Underwriters Laboratories Inc. (E312979) As of the date of manufacture, the CEN-WAP-ABG-1G and CEN-WAP-ABG-CM have been tested and found to comply with specifications for CE marking. FCC ID: MXF-M930907 Compliance Statement (Part 15.19) -
Page 15: Setup
Ethernet networks. These networks operate at speeds of up to 100 Megabits per second (Mbps) using the 100BaseT standard. For information on connecting Ethernet devices in a Crestron system, refer to the ® latest version of the Crestron e-Control Reference Guide (Doc. - Page 16 Phillips Pan Head Screws Rack Mounting The CEN-WAP-ABG-1G mounts horizontally into a rack and occupies 1U (1.75 inches) of rack space. NOTE: It is recommended that the access point be mounted into a rack only if the connected Wi-Fi devices are to be used less than 20 feet away from the access point and have line of sight to the access point.
- Page 17 Crestron CEN-WAP-ABG 802.11a/b/g Wireless Access Points To mount the CEN-WAP-ABG-CM to a ceiling: 1. Remove the cover by inserting a screwdriver into the notch at the bottom of the access point and pushing the base of the unit upward until it detaches from the cover.
-
Page 18: Hardware Hookup
Hardware Connections for the CEN-WAP-ABG-1G (Rear View) NETWORK PoE: TO 10BaseT/100BaseTX 802.3af-COMPLIANT POWER SOURCE CEN-WAP-ABG-CM The hardware connection for the CEN-WAP-ABG-CM is shown below. Hardware Connection for the CEN-WAP-ABG-CM (Rear View) NETWORK PoE: TO 10BaseT/100BaseTX 802.3af-COMPLIANT POWER SOURCE 14 • 802.11a/b/g Wireless Access Points: CEN-WAP-ABG... -
Page 19: Configuration
Have a question or comment about Crestron software? Answers to frequently asked questions (FAQs) can be viewed in the Online Help section of the Crestron website. To post a question or view questions you have submitted to Crestron’s True Blue Support, log in at http://support.crestron.com. - Page 20 Point” on page 17. Using the Crestron ToolBox NOTE: To be able to use the Crestron Toolbox to access the configuration utility of the access point, the UPnP (Universal Plug and Play) Ethernet protocol configuration setting of the access point must be enabled. The UPnP protocol is enabled by default.
Need help?
Do you have a question about the CEN-WAP-ABG and is the answer not in the manual?
Questions and answers