Summary of Contents for HTG 800LE
- Page 2 Contents 4.2.5 Lift the machine 4.2.6 Precautions 1. Introduction 4.3 Transportation 4.3.1 Manual transportation 1.1 Summary 4.3.2 Automatic transportation 1.2 Responsibility 4.3.3 Transportation and storage 1.3 Accessories 4.4 Start and stop the grinder 1.4 Package acceptance 4.5 Replace abrasives 1.5 Machine name plate 4.6 The wire winding 1.6 Handling and storage 4.7 Optimal grinding route...
- Page 3 This warranty covers only manufacturing defects. Pantheon does not assume damage in the transport, unpacking or operation. The manufacturer is not responsible for any damage or defects caused by improper use, corrosion or use of specifications beyond the noted specifications. The Pantheon machine are used to handle the floor surface.
- Page 4 17. After installing the abrasive, keep the grinding plate touch with ground directly, adjust handle bar to the The 800LE is a self propelled grinder. The forward/reverse switch can be used to control the forward and "lifting position", so that the operator could operate the machine easily.
- Page 5 rotating mechanical parts, but also reduces the exposure of dust and improves the dust absorption efficiency of the vacuum cleaner. When dry grinding, to prevent dust from being exposed to air, posing a threat to the health of the operator and nearby people, make sure that the vacuum cleaner is connected to grinder (preferably equipped with a vacuum cleaner manufactured by Pantheon ) Due to inhalation of dust is harmful in the course of operation, even there is a vacuum cleaner protective mask is also necessary to protect health.
- Page 6 produced by Pantheon to ensure the vacuuming efficiency. Bad vacuum cleaner is likely to clog the dust in forward / revers switch, resulting in a switch failure. Grinding machine needs to be connected to a vacuum cleaner in drying grinding. As shown in figure, connect suction hose to the connector.
- Page 7 1. The clutch may be stuck sometimes when you try to pull out, shake the machine in this case. 2. Rotate the clutch to proper position when grinding. Be sure to limit the clutch pin before working. 3. When pulling or rotating the clutch device, be sure to put the additional weight in working position first During transportation, adjust the additional weight iron, to prevent the iron from injuring or hitting people, causing unnecessary casualties.
- Page 8 (The specific adjustment actions of each component are described above. The adjusted machine is shown below. 1. When lifting the machine, it may cause personal injury or damage to the machine and surrounding 2. Locking the clutch device: When the machine starts working,, unscrew the clutch device, then pull out objects.
- Page 9 (2)Lock the clutch pin (unlock the clutch pin if in Turn on the emergency stop switch, rotate the speed regulator to adjust the rotation speed of the the manual mode), plug in the power cord motor, turn the switch to the left to rotate the motor ( ensure that the emergency stop is pressed During machine working process, the wire wind method is particularly important, you can greatly forward (rotate to the right to reverse the motor)
- Page 10 positive and negative knob to start the machine (Safely and normally start the machine, the running light will light up, if not normally start, then there will be the error code showed on the display screen) Remove the vacuum tube connection, illuminate the Turn on the grinder and press the emergency stop switch to see if the machine stops.
- Page 11 The table and picture show the technical data and dimensions of the grinder. Pantheon PAGE PAGE...
- Page 12 Pantheon does not bear the cost of machine damage caused by improper transportation, unpacking and improper use. Local distributors may be subject to specific warranty terms, please contact with your local distributor for specific warranty terms. PAGE PAGE...
Need help?
Do you have a question about the 800LE and is the answer not in the manual?
Questions and answers