Page 1
2 ✗ 2 Electric Adventure Motorbike USER MANUAL MODEL: 2 ✗ 2 SE 2023...
Page 2
Welcome to your 2023 Special Edition 2 ✗ 2 Congratulations on your uniquely numbered, limited edition bike. For the 2023 Special Edition, our product design team has created a fresh twist on the classic 2 ✗ 2 Adventure bike. The Special Edition has been designed to intertwine both outdoor and urban worlds, catering to the everyday adventurer.
VIN, which is engraved on the right-hand side of the frame head tube. Next: Scan this code with your smartphone to download the UBCO App. Keep the app updated and it will keep your bike up to date. CONTENTS Enable Bluetooth and location services on your phone 1.
2.2 Fit the rear indicators 2. ASSEMBLY Unpack the rear indicator lights. Install indicators to Before You Start their respective side on the rear light bracket. Check Under your seat in the Field Kit, you'll the orientation – the indicator with a long cable is find all the tools to assemble your fitted to left side, the short cable goes to right side.
Page 5
2.4 Install the battery 2.6 Pre-Ride Checklist IMPORTANT: Inspect the battery; contact UBCO DO NOT ride the bike if it is materially if there is any damage from transit. defective, damaged, or missing safety- related equipment. Physically check each If the battery is not already in place, remove the of these items before you ride.
Weight ( ex Battery ) 52.7kg 116lbs production information available at the time of approval Height 1,040mm 41in for printing. UBCO Ltd reserves the right to make Seat Height 830mm 32.6in changes at any time without notice. Width ( Handlebars 820mm 32.3in...
4. YOUR KEYS The 2 ✗ 2 is very quiet due to its electric motors and will not rev when it is turned The 2 ✗ 2 comes with two types of keys: a key fob and to Drive or when the throttle is turned. a securing key.
Neutral using the key fob or kill switch, open settings in the UBCO Rider's App and Turning off Security Mode will allow turn lights off, or hold the low beam switch until it anyone with access to the bike to turn it turns off (repeat to turn back on).
Regenerative braking system: To slow down, release the throttle to neutral position and then apply the Charge Mileage Power brakes: left = rear, right = front. The UBCO drive Le button Right button system incorporates a progressive regenerative Le indicator...
2. Press the right button to change between hours area. Find more information in the UBCO App or contact your local UBCO support line. and minutes. 3. Press the left button to cycle through numbers.
Page 11
7.3 Suspension Recommendations Spring Preload FRONT FRONT REAR REAR REBOUND SPRING REBOUND SPRING On-Road Max fast Full soft Max fast 20mm Rider Only thread exposed (90kg/198lb) On-Road Max fast 1 full turn 4 clicks 20mm Rebound Speed + Load to hard towards thread 7.2 Rear:...
9. YOUR BATTERY The 2 ✗ 2 features 19 individual accessory lugs that The UBCO 2 ✗ 2 battery and connections are made conveniently located around the bike frame and to do the hard work. Tested to an IP66 standard, the racks to provide flexibility and adaptability.
Page 13
The 2 ✗ 2 SE's battery is interchangeable with other BLUE – Flashing: Reverse polarity UBCO GenX5 2 ✗ 2 batteries, meaning that if you have more than one, you can swap them out to avoid charging downtime. Extra batteries are available Battery plug from UBCO Ltd or your UBCO dealer.
UBCO. Extra batteries and chargers can be Due to its electric drive motors, the UBCO 2 ✗ 2 is purchased from UBCO Ltd or your UBCO dealer. silent when on and very quiet in operation. When not in use, turn the bike off to prevent accidental throttle •...
Page 15
10.2 On-road Safety 10.4 Kickstand Safety • Inexperienced riders must take care and practice The UBCO 2 ✗ 2 comes with a manually retracted before entering traffic. kickstand that must be retracted before the throttle • Watch for changes in traffic.
11.2 Riding with a Load 11. LOADING THE 2 ✗ 2 With a load up to 100kg / 220lbs, the max gradient is 11.1 Loading Safety 15°/25%. With loads exceeding 100kg, maximum and Improperly loading your 2 ✗ 2 can affect its stability continuous gradients must be reduced accordingly.
• Inspect relevant wiring harnesses and connectors for damage. • Check / update firmware using the UBCO rider's app. The following table provides a list of potential codes • If you're unsure about anything contact your local service and the recommended remedial actions.
If the motors are overheating, they will reduce • Check the motor cables are properly connected. power. Check your UBCO App – if the motor • Check the motor temperatures on the UBCO App. temperature is over 95°C or 200°F, stop riding for If they’re over 125°C or 255°F, wait a few minutes...
Learner Mode using the • Before cleaning, turn the 2 ✗ 2 off. Ensure all power UBCO App. This will lower your speed and reduce outlets, including the battery, have their rubber power consumption, which will extend your range.
Page 20
Service • 4 months / 100hrs / 1,500km / 932mi Insist on only genuine UBCO parts being installed in • 7 months / 200hrs / 3,000km / 1,864mi your 2 ✗ 2 to ensure validity of the warranty. Regular •...
UBCO Limited may have under the Act. acceptable quality and the failure does not amount However, this warranty and any resultant express to a major failure.
Page 22
UBCO injury directly or indirectly resulting from any defect technician.
Page 23
VEHICLE COMPLIANCE FCC COMPLIANCE The UBCO 2 ✗ 2 is a type rated vehicle designed for This equipment has been tested and found to comply one rider only. It complies with the following country with the limits for a Class B digital device, pursuant vehicle regulations: to part 15 of the FCC Rules.
Need help?
Do you have a question about the 2X2 SE 2023 and is the answer not in the manual?
Questions and answers