Table of Contents
Advertisement
The communications settings are 9600 baud, 8 bits, no parity, 1 stop bit.
On the computer keyboard, use UPPER CASE letters for the commands.
Typed Letter
Action
Decrease channel 1 volume
Increase channel 1 volume
Decrease channel 2 volume
Increase channel 2 volume
J,K,L
The
keys do not affect the power amplifier output to the speakers or the three volume
settings.
J,K,L
Except for the
keys, holding a key down
or down.
When a letter is typed, the CCRC403 sends back that same letter.
It is not necessary or desirable to press the enter key after a letter entry.
The last volume setting of a channel is stored in a special memory. When the CCRC403 is turned
off and then back on, the stored volume settings are restored to their respective channels.
The volume controls have stops at both ends so that the volume setting won't wrap around from
minimum volume to maximum volume and vice versa.
In addition, decreasing the volume of a given channel past a certain minimum will mute that
channel.
When a channel is isolated from the line-out feed, the red overload LED for that channel on the
CCRC Control Panel will remain on steadily.
Instructions:
Control of the OWI CCRC403
Control Center.
Backview of CCRC403 showing RS232 connection
Typed Letter
Tech Support: 310-515-1900
Page 8 of 10
RS232
Remote
Action
Decrease channel 3 volume
Increase channel 3 volume
Toggle channel 1 in and out of the line out mix
Toggle channel 2 in and out of the line out mix
Toggle channel 3 in and out of the line out mix
(A,S,D,F,G,H)
smoothly moves the volume up
Filename:CONTROL CENTER MANUAL
12/11/06
Advertisement
Table of Contents
