Brod & Taylor ELECTRIC POUR-OVER KETTLE Instruction Manual

-
°C/°F
+
HOLD
ON/OFF
Before using the appliance
Perform the following procedure to clean the appliance.
1. Remove the spout cap and rinse out the inside.
2. Fill the appliance with 0.8 L of water (MAX level).
3. Boil the water.
4. Discard the boiled water.
While or shortly after using the appliance, it's surface, and
spout, the area around the steam vent of the lid and the power
Sleek Top Cover base is hot. Do not touch these parts. Doing so may cause
scalding (or burns). Hold the handle when using the appliance.
Smooth top cover is easy to lift and
locks firmly. Exclusive design eliminates
IMPORTANT SAFEGUARDS
water residue, avoiding bacteria.
When using electrical appliances, basic safey precautions
should always be followed, including the following:
1. Read all instructions carefully and thoroughly.
Precision Goose Neck Spout
2. Do not touch hot surfaces. Always hold the handle or knob.
A slow and steady pour wins the race.
3. To protect against fire, electric shock and injury to persons,
Our spout is designed for the optimal
do not immerse the cord, plug, kettle itself, or power base in
pour-over flow rate with to-the-drop
water or other liquids.
4. Close supervision is nevessary when the appliance is used
precision.
by or near children.
5. Unplug the appliance from the outlet when not in use and
before cleaning. Let it cool down before putting on or taking off
Counterbalanced Handle
parts, and before cleaning the appliance.
Our weighted handle shifts the center of
6. Do not operate any applicance with a damaged cord or plug
mass closer to your hand for an easier
or after the appliance malfunctions, or has been damaged in
pour.
any manner. Return appliance to the nearest authorized
service facility for examination, repair or adjustment.
7. The use of accessory attachments not recommended by
Brod & Taylor may result in fire, electric shock or injury to
304 18/8 Stainless Steel
persons.
8. Do not use outdoors.
High grade polished stainless steel for
9. Do not let the cord hang over the edge of a table or counter,
the best build quality.
or touch hot surfaces.
10. Do not place the appliance on or near hot gas or an
electric burner, or in a heated oven.
11. Do not use the appliance for anything other than its
intended use.
12. Close the lid firmly until it clicks or the automatic OFF
function may not work.
13. Hold the handle when removing the lid. Be careful not to
touch the hot surface of the kettle body or the nozzle after
boiling water.
14. Do not remove the lid during the boiling cycle. Doing so
may result in scalding (or burns).
15. When unplugging the appliance, hold the power plug itself.
Do not pull the power cord.
16. Do not fill the appliance with water while it is on the power
base. Before placing it onto the power base, dry the bottom of
the kettle.
17. To prevent the risk of scalding (or burns), close the lid
firmly.
18. Take care not to scald yourself. Steam is emitted from the
steam vent or the spout during or after boiling. Steam is
Base Sensor
emitted when opening the lid.
Safe and accurate: Built in Strix
19. Use the appliance on a flat and heat-resistant surface. Do
controller, the world leader in kettle not use it on top of other electrical products.
20. Do not wash the appliance or the power base in a
controls from the UK.
dishwasher. Never use detergent.
21. Do not insert any foreign objects in slots or gaps of the
appliance.
22. Do not try to disassemble or repair the appliance, or try to
replace the power cord yourself.
23. The appliance is for household use only.
Hi-Res LED Screen
Always attach plug to appliance first, then plug cord into the
Simple interface and advanced
wall outlet. To disconnect, turn any control to "off", then remove
temperature control engineering
plug from wall outlet.
allows for a easy temperature control
Scaling may occur if the lid is removed during the brewing
and adjustments.
cycles.
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance
by a person responsible for their safety.
Children should be supervised to ensure that they do not play
with the appliance.
If the SUPPLY CORD, is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualifiied persons in
order to avoid a hazard.
SAVE THESE INSTRUCTIONS
Safety Overview
To boil water, follow operational instructions in manual.
When water has boiled, the power automaticaly turns off
unless the "keep warm" function is used.