Switel D7010 Vita Plus - Cordless Handset Manual

Please read carefully before using this equipment.

Connect the cordless handset

You can register this handset as an additional handset on a D7000.

1. Remove the battery compartment cover and insert the batteries into the battery compartment. Pay attention to the correct polarity!
2. Close the battery compartment again.

For a full charge, the handset must be left in the charger for at least 15 hours (check the charger's power supply!).

Use only the batteries supplied with this product. If the batteries need to be replaced later on the same battery type must be used. For pluggable equipment, the socket-outlet (power adaptor) shall be installed near the equipment and shall be easily accessible.

Registering the handset (D7000)

1. Press the paging button on the base station for approx. 5 seconds until it flashes red / blue.
2. Press Menu, select Registration and press Select.
3. Select a base and press Select.
4. Enter the base station's PIN code (in delivery state 0000) and press Select.

Technical details

Power adaptor information

Something High Electric (Xiamen) Company Inc., P12DUSB050100 EU, Input 100-240V AC, 50/60Hz, 300mA, Output 5VDC, 1A

Note

For further information on operation, disposal and warranty, please refer to the operating instructions for your D7000.

Declaration of conformity

This device fulfils the requirements stipulated in the EU directive: 2014/53/EU.
Conformity with the above mentioned directive is confirmed by the CE symbol on the device. To view the complete Declaration of Conformity, please refer to the free download available on our website www.switel.com/support.

Telgo AG, Route D'Agy 16, 1763 Granges-Paccot, Switzerland

Service

In the case of technical questions, please use the service form on our website: http://www.switel.com/en/product-information-technical-support/