Table of Contents
Advertisement
Quick Links
Introduction
The LDHD2AZW is designed to secure the perimeter of the residential premise and provide the ability to
add various automation services. The LDHD2AZW, which consists of a sensor and a magnet that
attaches to a door or window, will communicate door or window events to the home security system.
When the magnet is moved away from the sensor, a signal will be sent to the control panel that
communicates the changed state to the security system. Signals can also be used to activate a chime or
convenience lighting based on system settings.
The LDHD2AZW is designed to be installed indoors only.
The LDHD2AZW is compatible with the following Touch Screen: Technicolor TCHT2AA0.
Specification
Frequency
Battery Type
Operating
Temperature
Storage Temperature
Battery Life
Ratings
Ferrous Materials
Dimension
LDHD2AZW Installation Guide
2.4GHz
CR2 Battery, Jauch P/N - 245718
0° C to 49° C (32°F - 122°F)
-20° C to 60° C (-4°F - 140°F)
5 Years (Not verified by UL)
3V/0.2A
Sensor gap distance performance may be varied if installed on ferrous
material with a minimum gap of 1" and maximum gap of 2"
Sensor Device: 80.4mm x 23.1mm x 23.2mm (3.17" x 0.91" x 0.91")
Magnet: 35.1mm x 12.3mm x 13.4mm (1.38" x 0.48" x 0.53")
Spacer: 3mm and 6mm (0.12" & 0.24")
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Comcast LDHD2AZW
Summary of Contents for Comcast LDHD2AZW
- Page 1 LDHD2AZW Installation Guide Introduction The LDHD2AZW is designed to secure the perimeter of the residential premise and provide the ability to add various automation services. The LDHD2AZW, which consists of a sensor and a magnet that attaches to a door or window, will communicate door or window events to the home security system.
- Page 2 Installation NOTE: The LDHD2AZW is for indoor use only – it MUST be installed indoors. NOTE: This LDHD2AZW shall only be installed on painted wood and steel surfaces for UL applications. 1. Once paired the LED will blink either a red, green, or amber color providing a visual indicator of the communication performance with the home controller or security system.
- Page 3 4. When mounting the magnet, add spacers as necessary to ensure the back of sensor and magnet are on the same plane. Peel the paper off one side of the double-sided tape provided, attach to the back of the magnet or spacer and press firmly for a few seconds. Peel the paper off the back of the magnet or spacer, align the magnet to the sensor and press firmly for a few seconds.
- Page 4 RF environment. Install a repeater so the system's range can reach the desired location for the sensor. 3. Perform a Factory Reset and then Re-pair the sensor as indicated in the steps above. Certification and Compliance 1. The LDHD2AZW certification and compliance statement can be found here: XHD2-LD Door/Window Sensor FCC.
Need help?
Do you have a question about the LDHD2AZW and is the answer not in the manual?
Questions and answers