Page 1
GROUP 0+ / I/ II / III(0-36 kg) ISOFIX SEMI-UNIVERSAL 0-18KG UNIVERSAL/ SEMI-UNIVERSAL 15-36KG 044737 The product has been approved according to the strictest European safety standards (ECE R 44/04) and is suitable for Group 0+/I/II/III(0-36KG)
Contents Introduction Introduction Dear Parents: Thank you very much for purchasing our product. Content..................1 The functions and design of this car seat offer safety and comfort when Introduc on................2 Important.................3-4 your child is in this child restraint. Know your car seat..............5-6 In order to use safely, please adjust the child restraint till it is suitable for Car seat Version................7 your child .
Important Important Do not use this child seat in passenger seats are equipped with airbags. It is recommended that the car seats should not be used more than 5 years Read this instruc on manual carefully. from the date of production. The properties of the products may deteriorate The correct fi...
Page 4
1.Headrest 8.Support leg indicator 2.Shoulder belt guide 9.Headrest adjusting loop 3.Shoulder pads 10.Baby insert 11.Harness Buckle 4.Shoulder strap 16.Instruction storage 21.ISOFIX Release button 12.Crotch pad 5.Harness adjusting button 22.Support leg adjusting button 17.ISOFIX LED 13.Base 6.Harness adjusting strap 23.Support leg block 18.ISOFIX connector 14.Rotating button 7.Function indicator...
Notice Car seat Version&Notice This child restraint is classified for "Semi-universal" use and is suitable for fixing into the 1. Car seat Version seat positions of the following cars: FRONT REAR Rota on Baby le ISOFIX Support Buckle Baby/Child Basic ISOFIX Centre Outer...
Please read the instruc ons carefully and keep safely for future reference. There is an instruc ons compartment in the back of the Jovikids child car seat for storage of the instruc ons manual. WARNING Group DO NOT use the child seat forward facing when your child is below 9kg.
Use in the vehicle 6. Securing your baby In the direc on of travel Against the direc on of travel 6.1 Using Baby Insert With 2-point belt Using 2-point belt will radically increase the risk which an accident bring to your child.
6.2 Cuddleme system 6.3 Harness system & Headrest adjust The cuddleme insert gives your baby the necessary support while he or Loosen the shoulder straps by pressing the harness adjus ng 5.3.1 she is small. bu on and pull the shoulder straps as far forward as The child safety seat must be used with seat insert un l your baby has possible.
Installation in the vehicle 6.4 To change the reclining posi ons 7.1 Installa on instruc on for Group 0+/I(0-18kg), Rearward facing , ISOFIX + Support Leg + harness. There are 5 recline posi ons of this product. Please use the most reclined posi on when Turn on the power switch.
Page 10
Installation in the vehicle Installation in the vehicle Grasp the seat body to check the Loosen the shoulder straps by pressing the harness 7.1.1.4 7.1.1.7 seat if it is fastened tightly or adjusting button and pull the harness shoulder as far shakes, meanwhile observe the forward as possible.
Installation in the vehicle Installation in the vehicle 7.2 Installa on instruc on for Group I(9-18kg), Guide the two buckle latches together and engage them 7.1.2.3 before pu ng them into the buckle, this should make a Forward facing , ISOFIX + Support Leg + harness. clicking sound.
Page 12
Installation in the vehicle Installation in the vehicle Grasp the seat body to check the Loosen the shoulder straps by pressing the harness 7.2.1.4 7.2.1.7 seat if it is fastened tightly or adjusting button and pull the harness shoulder as far shakes, meanwhile observe the forward as possible.
Installation in the vehicle Installation in the vehicle 7.3 Installa on instruc on for Group II,III(15-36kg), Guide the two buckle latches together and engage them 7.2.2.3 before pu ng them into the buckle, this should make a Forward facing,vehicle 3 point + FIT. clicking sound.
Page 14
Installation in the vehicle Installation in the vehicle Squeeze the support leg 7.3.5 7.3.9 adjusting button, slide the support leg block upwards. Remove the baby insert, loosen the shoulder straps by 7.3.6 pressing the harness adjus ng bu on and pull the harness shoulder as far forward as possible.
Installation in the vehicle Installation in the vehicle 74 Installa on instruc on for Group II, III (15-36kg), 7.3.6 Forward facing, vehicle 3 point. Squeeze the support leg 7.4.1 adjusting button, slide the support leg block upwards. Remove the baby insert, loosen the shoulder straps by 7.3.2 Adjust the height of the headrest to suit your child.Put the vehicle belt pressing the harness adjus ng bu on and pull the...
Care instructions Care instructions 8.1 Cleaning NOTICE: The ba eries used in this system are NO. 5 version. Ba ery replacement procedure: Please be sure to use only original cover, as the cover is quite important for 1. Use a cross screwdriver to open the ba ery box cover at the bo om of the the secure opera ng system.
Need help?
Do you have a question about the WD001 and is the answer not in the manual?
Questions and answers