HiRec BOOM PUCK - Waterproof Wireless Speaker Manual

Introduction

The BOOMPUCK Wireless Speaker can be used with tablet, notebook and other types of smartphone to stream music, and enjoy handsfree calling. ln order to get the best results when using the device, please read this manual first before using.

Features

• Volume control
• Stunning sound
• Ultra portable design
• Great for parties, indoor and outdoor
• Hands free calling facility

Package Contents

Important Safety Precautions

When using your BOOMPUCK Speaker, basic safety precautions should always be followed, including the following:

1. Keep this product and its charging cable away from excessive heat.
2. Do not operate this device with a damaged cable or after il has malfunctioned or has been damaged in any manner.
3. Do not disassemble your deviee.
4. To avoid eletrical failure, use within tested rating of submerged in up to 1 metre of water for a 30 minute duration.

Charging Your Speaker

1. Connect one end of the included USB Charging Cable to the Charging Port on your speaker. Then plug the other end of the USB Charging Cable into a suitable USB port on your computer to recharge your speaker's internal rechargeable battery.
   NOTE: The internal battery of your speaker takes approximately two hours to charge when completely drained.
2. When charging, a red LED light will illuminate to indicate that the unit is charging. The red light will turn off when your unit is fully charged.

A Quick Look at Your Device

1. Previous: Press and hold to access the last track in playlist. Press to lower the volume.
2. Phone: Press this button to activate the speaker phone function. When music is playing, press to play or pause a track.
3. Next: Press and hold to access the next track in a playlist. Press to increase the volume.
4. Charging Port
   
   You can plug one end of the included USB Charging Cable into this jack, while plugging the other end into a USB port on your computer in order to charge your speaker's built in lithium battery.
5. ON/OFF Switch
   
   Press and hold the""for power ON
   Press and hold the""again for power OFF

Understanding the LED Status Lights

When Charging Your Speaker
Solid red LED = Charging
No red LED = Charge Complete

When Pairing Your Speaker to a Bluetooth Audio Source
Rapid blinking blue LED: Device not connected. (Ready to pair.)
Solid blue LED: Device connected.

Pairing Bluetooth Devices to Your Speaker

ln order to pair your Bluetooth audio device to your Wireless Speaker for the first time, follow the steps below:

1. Make sure your Bluetooth audio source is held within three meters of your speaker.
2. Press and hold the "" switch on your speaker to power on.
   The LED light will blink blue to indicate that you have entered pairing status.
3. Go to the Bluetooth Manager of your Bluetooth audio source. Please refer to the User's Manual of your Bluetooth audio source for more information.
4. Search Bluetooth devices and select "BOOMPUCK"
5. Once paired, the blue LED light will be solid and you can use your speaker to listen to audio from you Bluetooth sound source.

Using the Hands-Free Function

When an iPhone or other smartphone is connected to your speaker follow the steps below to take calls hands-free.

1. Press "" to pick up the call.
2. Press and hold "" for 2 sec to reject the call.
3. During a call: Press "" again to hang up the call.

Troubleshooting

Specifications

Loudspeaker: 4Ω 5W

Built-in Power: Li-ion 600mAh

Dimensions: 93mm(W)*93mm(L)*42mm(H)

SNR: 80± 3dB

Wireless Working Frequency: 2.402-2.480 Ghz

Wireless Transmission Distance: up to 1 Om

Charging Time: 1-2 hours

Weight: 180 g

Speaker Dimension: 45mm

Charging: DC 3.7V/500mA