Page 2
WE JUST WANT TO SAY THANKS First and foremost… If you’re reading this, you’ve used your hard earned dollars to support Exodus and our mission to build better hunting products and experiences with our customers top of mind! We humbly and graciously want to thank you! In the Exodus Rival user resource guide you’ll find everything...
The Exodus Advantage and Warranty The Exodus Advantage is home of the industry’s first 5 year trail camera warranty and still the only to offer accidental damage and theft policies. During that time period, if any failures occur due to manufacturing under normal working conditions we will repair or replace your camera with the same model.
Page 5
On the outside of your camera there will be a warranty QR code to scan for product registration. Use the production number as the serial number. Your camera must be registered within 30 days of purchase for valid warranty policies. There are no exceptions as you have to remove the QR sticker to use the camera.
Exodus Rival SD Card Requirements The Exodus Rival can support up to a 128GB SD. With remote management, we recommend a 32GB Exodus brand SD available here (link) or any major American brand SD with speeds no faster than 120Mb/s.
• Insert 8 AA Lithium batteries into the battery housing • Insert a new SD card meeting the Exodus Rival requirements • Screw the antenna on to the camera, making sure the rubber gasket is in place, and the antenna is hand tight.
Page 8
Go to www.scoutek.com and Sign In Click the Register Camera button Select Exodus Rival A Referencing the QR code sticker inside the camera housing, enter the required information Name your camera and click Register Camera *If you have multiple cameras to register click Register Another...
The Exodus Rival On Camera Controls The Rival’s main switch has 3 positions Online - Camera will operate via cellular network when properly activated and setup. All settings will be controlled through the mobile app. Off - Camera is powered OFF...
Page 10
Green: 4-5 bars Yellow: 2-3 bars Red: 0-1 bar *The Rival must have a min of 2 bars of service for function. Like any cellular device, overall function and performance will be dictated by the available signal. Connectivity Level Icon...
Rival Settings and Values On Demand: When checked, the Exodus Rival will have “Live” abilities to process OTA commands. UPLOAD INTERVAL : Setting to control when files will be uploaded. Status reports will upload according to the set upload...
Page 12
Time Lapse - Photos will be recorded at the set time intervals programmed *Time Lapse W/Motion: When checked, the Exodus Rival will also be triggered by PIR detection. This feature is only applicable when programmed in Time Lapse mode.
Page 13
15 seconds to most consistent performance. Trigger Sensitivity The Rival offers different PIR sensitivity levels to allow each user to fine tune the specific setup for the most practical use cases with the highest setting reaching out to 72’. Values range from 0 to 9.
“all” photos. It is best practice to use the unique camera name on the photo label. Exodus Rival Format Function To format SD cards inside the Exodus Rival Insert compatible SD card and power the camera to Offline mode.
Open your mobile app Select the desired camera from the Cameras page Click Actions and select Update Firmware The Rival System Status LED will blink red during the FW update. *To use OTA FW updates the camera must be powered to Online, active, and connected to the network.
Page 16
FCC Statement: NOTE: Changes and modifications not expressly approved by the party responsible could void the user’s authority to operate this device. This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the RIVAL and is the answer not in the manual?
Questions and answers