Advertisement
PARTS DIAGRAM
ASSEMBLy INSTRUCTIONS (CONTINUED)
Step 7:
Insert bottom shelf (Part #18) between the four legs, flat side
facing up towards the ceiling. Make sure the side with 3 holes
is on the same side as corresponding large oval hole in the
middle section and the black tubes at the top. Insert sixteen
Torx bolts (Part #1A) and finger tighten.
1A
18
Step 8:
Carefully lift cart onto its casters.
Step 9:
Open sliding top using the key provided.
Step 10: Assemble the brackets (Part #5) to the comfort grip push
handles (Part #6); then mount push handles and brackets
to both sides of the cart using the eight Torx bolts (Part #1B)
provided. Finger tighten at this time.
5
6
1B
MB197UC, -BK, -BL, -FBK, -GRAY, -LG, -OR, -WT, -YE
All manuals and user guides at all-guides.com
1A
1B
3
MB197UC, -BK, -BL, -FBK,
-GRAY, -LG, -OR, -WT, -YE
DELUXE UTILITY CART
Step 11: Insert the remaining 8 Torx bolts (Part #1A).
15
18
Step 12: Completely tighten all fasteners!!
Step 13: Insert spray can dividers (Part #15) into provided channels
on the bottom shelf (Part #18).
TROUBLESHOOTING
Troubleshooting Points during MB197UC Assembly.
Problem: Drawers appear not to fit, do not slide in accurately and
bump the cart sides.
Solution: The roller bearing slides must be fully engaged into the
mounting slots on all drawers. They potentially could fall out of
position while turning the cart on its lid, back, or onto its casters.
Remove the drawer that is out of position. The drawer is removed
by the two clips on the roller bearing slides.
Simply push the roller bearing slide back down into position.
Insert the drawer back onto the roller bearing slides.
Problem: Back Lock/Unlock Switch does not engage the drawer.
Solution: The inside Lock/Unlock slide potentially could fall out of
its groove while turning the cart on its lid, back, or onto its casters
during assembly.
Unscrew the two screws that are holding the Lock/Unlock slide in
place.
Once the screws are removed simply place the latch back onto the
slide and tighten the two screws back down.
3 DRAWER
Rev. 12/22/15
Advertisement
