Oregon Scientific 17015 User Manual page 32

No sound is produced:
1) Are the channel volumes and the master volume turned up on the console, and are the channels turned on? Please refer to
the chapter on the Mixer Window.
2) Check all the cable connections as described in the chapter on setting up the console.
3) Check that your PC can play wav sounds: Exit the Wav DJ program and test your speakers by going to the Control Panel
in the Start Menu Settings area. Double click the Sounds and Multimedia icon. You can use the play function to listen to
a system sound from here.
4) If you still cannot hear anything make sure that your sound card is connected and that the sound card drivers are properly
installed. Please refer to your sound card manual.
I cannot play MIDI sounds (keyboard and drum instruments and parts of the song):
Check that your sound card drivers are correctly installed. Please refer to your sound card manual when troubleshooting
sound problems.
The microphone does not work:
1) Make sure that the microphone volume slider is turned up and that the track is turned on. Remember that the microphone
and the Line In tracks cannot be turned on together.
2) Check the connection leads.
I get feedback when using the microphone:
If you are using the PC speakers to monitor the sound output you might experience loud unpleasant noises. To reduce the
chances of this happening make sure that the speaker volume is not too high when you use the microphone and increase the
distance between the microphone and the speakers.
After I exit the program my sound settings have been altered:
When the Wav DJ software runs it scans the system mixer settings and stores them. When the software is running the mixer
settings will be changed as you make changes. The original system settings are restored when you exit. If you reboot the PC
or it crashes before you exit then the system settings will not be restored.
29