Advertisement
Keep the followings to prevent damages, electric shock, fume and fire.
Do not connect
to AC power.
NG!
Do not separate the mounting channels at
the gap (joint parts) between mounting bases.
Product may be damaged when gap (joint parts)
moves each other.
NG
channels(separate)
OK
Channel holds the product even gap (joint parts) moves.
Caution when Installing the Product
Do not use a tool
with sharp point .
NG!
channels
Do not tramp on or
strike the product.
NG!
Do not bend the product toward vertical
direction.
mounting
bases
Do not pull out the product
diagonallyfrom the channel.
NG!
Vertical direction.
NG!
Horizontal direction.
Minimum bending radius is 60 mm.
OK
NG!
OK
Advertisement
Table of Contents
Summary of Contents for Atex Tsubaki Seamless Light Type H RGB color
- Page 1 Caution when Installing the Product Keep the followings to prevent damages, electric shock, fume and fire. Do not connect Do not use a tool Do not tramp on or Do not pull out the product to AC power. with sharp point . strike the product.
-
Page 2: Product Specification
Tsubaki Seamless Light Type H RGB color (GLD-F) For Keeping Instruction Manual Atex Co.,ltd. ZTE2GLDF Ver.220720 We will appreciate for your purchasing the product. Please carefully read this manual to install the product correctly and safely. The contents described on this manual are subject to change without prior notice. - Page 3 ◼ Dimension +24V Note When connecting products and power supplies in parallel i n multiple systems, make sure that the types and lengths of the wires in each system are the same to prevent differences in brightness and color between the products...
-
Page 4: Wiring Method
Wiring Method ◼ Example of wiring ◼ Maximum series connection length Follow the documents of dimming controller, power supply and DMX Driver that you use. Follow the specifications of the equipment and wires used for wiring. The product length to be connected in series should be 10.1 m or less. ◼... -
Page 5: Installation Method
CAUTION Use Atex accessories to install the product. Do not put the screw on the product directly. It may cause damages. Do not use double sided tape and glue to install the product. - Page 6 ◼ In case of removing from the channel 1. If you have to shorten a length of the product, refer to “How to cut the product at site”. We DO NOT recommend to remove the product from the channel after the installation. Repeated 2.
Need help?
Do you have a question about the Tsubaki Seamless Light Type H RGB color and is the answer not in the manual?
Questions and answers