Download Print this page

K'Nex Dancing Robot Quick Start Manual

Table of Contents

Download this manual

K'NEX Dancing Robot

The K'NEX Dancing Robot kit includes 2 x K'NEX Control Motor, and all the K'NEX parts needed to build the robot.

In addition to the kit, you will need either:

1. Learn & Go computer control box, with a battery holder and 4 x "C" batteries, or

2. Egg-Box computer control box, with a battery holder and 4 x "C" batteries.

If you buy your Learn & Go from us, you will receive a free 4 x "C" battery holder.

Note that the instructions provided in this section consist only of a series of photographs of the part-completed and

finished models. Please email us if you feel that any stage of the assembly process is unclear.

K'NEX Dancing Robot

<< Stage 1

First, build the three sub-assemblies shown in the photo.

Note that the lug on the Tan Interlocking clip fits inside one of the small holes in the wheel, so that when

the rod is rotated, the wheel is also rotated.

Stage 2 (x2) >>

Then, for each motor, push the blue rod in the

wheel/axle sub-assembly right through the central hole

in the motor.

Page: 1

Table of Contents

Need help?

Do you have a question about the Dancing Robot and is the answer not in the manual?

Page 1 K’NEX Dancing Robot The K'NEX Dancing Robot kit includes 2 x K'NEX Control Motor, and all the K'NEX parts needed to build the robot. In addition to the kit, you will need either: 1. Learn & Go computer control box, with a battery holder and 4 x "C" batteries, or 2.
Page 2 Now attach the other sub-assembly from Stage 1 to one of the motors, using two red rods... << Stage 4 ..and attach the second motor, as shown.. Stage 5 >> Create six more sub-assemblies... Copyright © K’NEX User Group 2008 K’NEX Dancing Robot Page: 2...
Page 3 Stage 6 >> ..and attach them to stage 4, as illustrated. << Stage 7 (Egg-Box) If you are using an Egg-Box, add the battery holder with batteries inserted, as shown. Copyright © K’NEX User Group 2008 K’NEX Dancing Robot Page: 3...
Page 4 You will need to add two white rods, as shown in the photo, to hold the Learn & Go box in place. Stage 9 You can now “program” your Egg-Box or Learn & Go, in accordance with the instructions provided with that device. Copyright © K’NEX User Group 2008 K’NEX Dancing Robot Page: 4...