Table of Contents
Advertisement
Quick Links
PING PONG TABLE
B EFORE YO U START
Unpack and lay all Ping Pong Table pieces
flat on a padded surface to avoid scratching
or damaging the components.
Look for an engraved letter near each slot on
the enclosed riser pieces. Always match up
coordinating slots (A+A, B+B, etc.) to ensure
proper assembly.
Locate and count all hardware before
discarding any packaging.
R E Q U IRED TOOL S
(20) KEYS
ALLEN WRENCH
I M P O RTANT NOTE
The Ping Pong Table is designed for
on-deck use only.
(22) SCREWS
Align the corresponding slots of the bottom
STEP 1:
crossbars and the table legs. Make sure the letter
system is facing the inside of the table. Slide the
pieces together, using a mallet if needed. Continue
until all four pieces are assembled together.
K
J
I
E
A
Align the corresponding letters of the shelves
STEP 2:
and drop them on the L-slot tabs. Slide inward until it
locks into place, using a mallet if needed.
K
J
I
E
A
B
B
C
L
F
L
F
Advertisement
Table of Contents
Related Manuals for LEDGE PING PONG TABLE
Summary of Contents for LEDGE PING PONG TABLE
- Page 1 Make sure the letter system is facing the inside of the table. Slide the Unpack and lay all Ping Pong Table pieces pieces together, using a mallet if needed. Continue flat on a padded surface to avoid scratching until all four pieces are assembled together.
- Page 2 Align the corresponding letters of the two Insert the (20) keys into the key slots located STEP 3: STEP 6: brackets and insert them into the table legs. Slide the on the brackets. Do not screw the keys into place pieces together, using a mallet if needed.
- Page 3 POWER WASHI NG Use caution to avoid inscribing your ping pong table. Start with a very low PSI at least 3 feet away from furniture, and test on the under side before moving closer.
Need help?
Do you have a question about the PING PONG TABLE and is the answer not in the manual?
Questions and answers