Summary of Contents for FLUXE M3P U Series
- Page 1 Engery for the Future USER MANUAL M3P U-SERIES LEVEL 2 AC EV CHARGER | MODEL FX-EV-002-BLK...
- Page 3 FLUXE M3P U-Series Level 2 AC EV Charger User Manual IMPORTANT SAFETY INSTRUCTIONS WARNING- When using electric products, basic precautions should always be followed, including the following. This manual contains important instructions for Models M3P132U and M3P140U that shall be followed during installation, operation, and maintenance of the unit.
- Page 4 FLUXE M3P U-Series Level 2 AC EV Charger User Manual CONSIGNES DE SÉCURITÉ IMPORTANTES AVERTISSEMENT- Lors de l'utilisation de produits électriques, des précautions de base doivent toujours être suivies, y compris les suivantes. Ce manuel contient des instructions importantes pour les modèles M3P132U et M3P140U qui doivent être suivies pendant l'installation, l'utilisation et la maintenance de l'unité.
-
Page 5: Table Of Contents
FLUXE M3P U-Series Level 2 AC EV Charger – FX-EV-002-BLK User Manual CONTENTS ABBREVIATIONS ............................... 5 SAFETY NOTES ..............................6 2.1. Safety signs used .................................. 6 2.2. Installation ....................................7 2.3. Maintenance ..................................8 2.4. Operation....................................8 STANDARDS COMPLIANCE .......................... 9 3.1. - Page 6 FLUXE M3P U-Series Level 2 AC EV Charger – FX-EV-002-BLK User Manual 6.6. Normally stop charging ..............................28 6.7. Abnormally stop charging ............................. 28 FAULT HANDLING AND MAINTENANCE ....................29 7.1. Fault Handling ..................................29 7.2. Maintenance ..................................31 WARRANTY AGREEMENT ........................... 32...
-
Page 7: Abbreviations
FLUXE M3P U-Series Level 2 AC EV Charger – FX-EV-002-BLK User Manual ABBREVIATIONS Abbreviations Description International Electrotechnical Commission Electrical Vehicle, this can be BEV (battery EV) or PHEV (plug-in hybrid EV) EVSE Electric Vehicle Supply Equipment [IEC61851-1] On-board charger (of an EV) -
Page 8: Safety Notes
FLUXE M3P U-Series Level 2 AC EV Charger – FX-EV-002-BLK User Manual 2. SAFETY NOTES 2.1. Safety signs used The following warning signs, mandatory signs and information signs are used in this manual, on and in the AC EV Charger. -
Page 9: Installation
FLUXE M3P U-Series Level 2 AC EV Charger – FX-EV-002-BLK User Manual Use protective footwear. Utilisez des chaussures de protection. Must wear a safety helmet. Doit porter un casque de sécurité. Indicates important texts, notes, or tips. Représente un texte, une note ou un indice important. -
Page 10: Maintenance
FLUXE M3P U-Series Level 2 AC EV Charger – FX-EV-002-BLK User Manual ▷ The lead nose of the Charger must be securely attached or there is a risk of damaging the equipment. Les fils du chargeur doivent être solidement connectés, faute de quoi le matériel risque d'être endommagé. -
Page 11: Standards Compliance
FLUXE M3P U-Series Level 2 AC EV Charger – FX-EV-002-BLK User Manual ▷ Forced charging is strictly forbidden when the electric vehicle or Charger fails. La charge forcée est interdite en cas de panne du véhicule électrique ou du chargeur. -
Page 12: Charging Interface
FLUXE M3P U-Series Level 2 AC EV Charger – FX-EV-002-BLK User Manual Case C: Connection of an EV to a supply network utilizing a cable and vehicle connector permanently attached to the EV charger. Fig. 3-1 Schematic diagram of CASE C connection 3.4. -
Page 13: Product Information
FLUXE M3P U-Series Level 2 AC EV Charger – FX-EV-002-BLK User Manual 4. PRODUCT INFORMATION 4.1. General Welcome to use Level 2 AC EV Charger produced by our company. 4.1.1. Shape & dimensions The shape & dimensions of AC EV charger shown as Fig. 4-1. -
Page 14: Specifications
FLUXE M3P U-Series Level 2 AC EV Charger – FX-EV-002-BLK User Manual 4.1.3. Model number definition The model number definition of charger follows the rules as shown in Fig. 4-3. □ U: Designed according to US standards Rated output current 32: 32A;... - Page 15 FLUXE M3P U-Series Level 2 AC EV Charger – FX-EV-002-BLK User Manual 4.2.2. Functional description Charging Mode Mode 3 Charging Control Remote: “APP-controlled” Local: “Plug and charging” or “Card-controlled” 4 LED lights; Indicator Lights Indicate 4 statuses include standby, charging, fault, and network WiFi (2.4GHz), Ethernet (RJ-45 interface).
-
Page 16: Nameplate
FLUXE M3P U-Series Level 2 AC EV Charger – FX-EV-002-BLK User Manual 4.3. Nameplate On the wallbox shell, there is a nameplate identifying the model and specification of the charger, the content is shown as Fig. 4-4. Fig. 4-4 The content of the nameplate... -
Page 17: Installation
FLUXE M3P U-Series Level 2 AC EV Charger – FX-EV-002-BLK User Manual 5. INSTALLATION 5.1. Unpacking 5.1.1. Packing list Package Quantity AC EV Charger 1 pc Empty socket 1 pc RFID card 2 pcs Wall-mounting accessories (including A+B+C+D as Fig. 5-1 shown) -
Page 18: Prepare
FLUXE M3P U-Series Level 2 AC EV Charger – FX-EV-002-BLK User Manual ▷ If any damage or missing parts are found, please do not start the machine, and contact the supplier as soon as possible. ▷ Please keep the packing box and packing materials 1 month for future handling. -
Page 19: Installation Of Sim Card
FLUXE M3P U-Series Level 2 AC EV Charger – FX-EV-002-BLK User Manual Fig. 5-2 Minimum space requirements for wall mounting It is suggested that the charger should be installed in a place with good ventilation, no direct sunlight and shelter from wind and rain. In order to ensure good ventilation condition, you should mount the charger vertically and leave enough space. - Page 20 FLUXE M3P U-Series Level 2 AC EV Charger – FX-EV-002-BLK User Manual Step 1: Open the front cover Fig. 5-3 Open the front cover As shown in Fig. 5-3, remove the six screws securing the cover in the direction of arrow [A], and then open the cover in the direction of arrow [B].
-
Page 21: Installation Steps
FLUXE M3P U-Series Level 2 AC EV Charger – FX-EV-002-BLK User Manual Fig. 5-5 Reset the front cover As shown in Fig. 5-5, first place the cover on the charging pile in the direction of arrow [B], and then tighten the six screws in the direction of arrow [A]. - Page 22 FLUXE M3P U-Series Level 2 AC EV Charger – FX-EV-002-BLK User Manual Terminal cover Gland of input cable Charging cable Gland of network cable Input power cable Fig. 5-7 Network wiring Loosen the gland [D], pass a network cable with RJ-45 header through the gland [D] and plug it ...
-
Page 23: Empty Socket
FLUXE M3P U-Series Level 2 AC EV Charger – FX-EV-002-BLK User Manual Fig. 5-9 Fixed the wallbox Tighten the accessories [C] on the left and right ends to fixed the wallbox as Fig.5-6 shown. 5.5. Empty socket M3P U-series AC EV charger config a type 1 charging connector. -
Page 24: Operation
FLUXE M3P U-Series Level 2 AC EV Charger – FX-EV-002-BLK User Manual 6. OPERATION 6.1. Power on After the charger has been installed and confirmed, switch on the power supply. The indicator light lights up and the charger switches to standby state. - Page 25 FLUXE M3P U-Series Level 2 AC EV Charger – FX-EV-002-BLK User Manual 6.2.2. LED indicators The LED indicators on the panel are used to indicate the status of the charger and the various combinations of indicators are described as below.
-
Page 26: Config Wifi Network
FLUXE M3P U-Series Level 2 AC EV Charger – FX-EV-002-BLK User Manual 6.3. Config WiFi network Prepare a WiFi router operating at 2.4GHz and an Android or iPhone smart phone. Make sure the charger and smart phone are in the WiFi coverage area. -
Page 27: Config The Parameters
FLUXE M3P U-Series Level 2 AC EV Charger – FX-EV-002-BLK User Manual Press WiFi configuration button (Fig.6-1 [c]) and until the indicator light fast twinkle (about 5Hz frequency), and the charger enters the WiFi network configuration state. Click the "CONFIRM" button on the phone. - Page 28 FLUXE M3P U-Series Level 2 AC EV Charger – FX-EV-002-BLK User Manual Fig. 6-5 Login of EVSE CONFIGURATION Step 3: Config your EV Charger Fill the default password “12345678” to enter the page shown in Fig. 6-6. Please change a new login password at the first-time login this webpage.
-
Page 29: Start Charging
FLUXE M3P U-Series Level 2 AC EV Charger – FX-EV-002-BLK User Manual Fill hotshot’s name and password of your WiFi router in the webpage. Click the “SAVE” button to save the settings, and click the “RESTART” button to restart charging station for settings take effect. -
Page 30: Normally Stop Charging
FLUXE M3P U-Series Level 2 AC EV Charger – FX-EV-002-BLK User Manual ▷ For iPhone, search “WE E-Charge” in APP Store or scan the QR code on the right to install APP. ▷ The user manual of APP please refer to the FAQ of APP. -
Page 31: Fault Handling And Maintenance
FLUXE M3P U-Series Level 2 AC EV Charger – FX-EV-002-BLK User Manual 7. FAULT HANDLING AND MAINTENANCE 7.1. Fault Handling If All LED are not on, please check： Whether the power supply and distribution are normal; Whether the branch breaker is tripped, and close the breaker after troubleshooting;... - Page 32 FLUXE M3P U-Series Level 2 AC EV Charger – FX-EV-002-BLK User Manual Fault code Handling method indicator twinkle 1×slow, 9×fast Fault code 19: Check whether the charging connector is correctly Output overcurrent connected. Check whether the OBC is normal.
-
Page 33: Maintenance
FLUXE M3P U-Series Level 2 AC EV Charger – FX-EV-002-BLK User Manual 7.2. Maintenance To ensure the long-term stable operation of the equipment, please maintain the equipment regularly (usually every month) according to the operating environment. The equipment is maintained by professionals. -
Page 34: Warranty Agreement
FLUXE M3P U-Series Level 2 AC EV Charger – FX-EV-002-BLK User Manual WARRANTY AGREEMENT The scope of warranty refers to the product itself. The warranty period is 12 months. During the warranty period, the company will repair the product free of charge in case of failure or damage (determined by the company's technical personnel) under normal use. - Page 35 FCC Warning Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
- Page 36 Engery for the Future www.fluxeenergy.com...