Advertisement
Quick Links
CORE 1 and CORE 3 Wall-Mount Bracket
Installation Guide
Box contents
• C4-CORE1-WM
Control4 CORE 1 Wall-Mount Bracket
OR
• C4-CORE3-WM
Control4 CORE 3 Wall-Mount Bracket
Description
These wall-mount brackets are designed specifically for use with the Control4 CORE 1 Hub and Controller (C4-CORE1) or Control4 CORE 3 Hub and
Controller (C4-CORE3). The brackets provide several mounting options, such as on-wall or behind a TV in various orientations. The brackets have
VESA-standard hole sizes of 75 mm, 100 mm, and 200 mm (CORE 3 bracket only) for use on the back of a TV or monitor when the VESA mounts are
not in use. Several wall-mounting options are available as well, including standard US single-gang and double-gang box mounting.
Important! Do not mount over 6 ft high (2 m).
Important: Ne pas monter à plus de 6 pi de haut (2 m).
Important! Mount the bracket with the tabs on the bottom (opening to the top) so the controller will not fall out of the bracket.
Important! Montez le support avec les languettes en bas (ouverture vers le haut) afin que le contrôleur ne tombe pas du support.
Installing the bracket
To mount the bracket behind the TV
For most TVs, the VESA mounts are unused when the
original TV stand is in use. The bracket can be installed
behind the TV and hold the controller for a clean
installation.
Note: Use the mounting screws that came
with the TV. Using a longer screw may
damage the TV.
VESA hole patterns shown in the images:
• 75 mm
• 100 mm
• 200 mm (CORE 3 bracket only)
To mount the bracket to a wall box
A standard US single-gang or double-gang wall box
can be used to install the wall-mount bracket. This
option is for convenience only, and high-voltage wiring
should not be located in the gang box when using this
option.
Wall box hole patterns shown in the images:
• 1 gang wall box
• 2 gang wall box
1 1
100 mm
100 mm
75 mm
75 mm
75 mm
75 mm
100 mm
100 mm
VESA patterns on the CORE 1 bracket
1 gang
2 gang
2 gang
2 gang
2 gang
1 gang
Wall-box patterns on the CORE 1 bracket
100 mm
100 mm
75 mm
75 mm
200 mm
200 mm
75 mm
75 mm
100 mm
100 mm
VESA patterns on the CORE 3 bracket
1 gang
2 gang
2 gang
2 gang
2 gang
1 gang
Wall-box patterns on the CORE 3 bracket
Advertisement
Related Manuals for Control 4 CORE 1
Summary of Contents for Control 4 CORE 1
- Page 1 Description These wall-mount brackets are designed specifically for use with the Control4 CORE 1 Hub and Controller (C4-CORE1) or Control4 CORE 3 Hub and Controller (C4-CORE3). The brackets provide several mounting options, such as on-wall or behind a TV in various orientations. The brackets have VESA-standard hole sizes of 75 mm, 100 mm, and 200 mm (CORE 3 bracket only) for use on the back of a TV or monitor when the VESA mounts are not in use.
- Page 2 Wall mount Wall mount Wall mount Wall mount Wall-mount patterns on the CORE 1 bracket Wall-mount patterns on the CORE 3 bracket Adding and removing the controller from the bracket To add the controller to the bracket: 1 Orient the front or back of the controller toward the top of the bracket (the bottom has tabs to keep the controller from sliding out.) The controller can be mounted either frontside-up or backside-up depending on the installation needs.