CodaOctopus Martech Watchdog2 Installation Manual

Test, Measurement and Control Solutions for Demanding Applications
Watchdog2 Fire Sprinkler Controller Installation Guide
This document provides essential information on how to install, configure and test the Watchdog2
The good news is the Watchdog2 is easy to install and requires minimum set up and configuration.
Key features:
Input connections for:
•
Dual pressure switch (monitored)
•
Flow switch (monitored)
•
Water level
Output connections for:
•
Pump
•
Diverter valve
•
Fire panel
•
Fault monitor
•
Low water alarm
USB connection for:
•
Uploading of advanced configuration files
•
Software updates
Watchdog2 has been designed with failsafe features
that help ensure that the pump will run when the
pressure drops (in the event of a sprinkler head
opening) even if the microprocessor or software fails.
WARNING – Watchdog2 is a safety critical device and
MUST be installed by a qualified electrician/electrical
engineer in accordance with relevant electrical
installation regulations and relevant fire sprinkler
regulations.
Failure to install and configure correctly may result in
the fire sprinkler system failing to operate, resulting
in loss of life or severe injury. Coda Octopus Martech
Ltd. (Martech) accepts no responsibility for failure of
any kind resulting from incorrect installation or from
installation by unqualified installers.
For additional resources and technical support, please visit
scan the QRcode:
Coda Octopus Martech Limited
17 Mereside, Osprey Quay, Portland, Dorset DT5 1PY, UK.
t: +44 (0)1305 770440 f: 07092 870664 martech@codaoctopus.com, www.martechsystems.co.uk
Company No. 02300406, VAT No. 510892555
A Coda Octopus Company, Headquartered in USA
www.firesprinklerwatchdog.com or
Page 1of 8