Page 2
Place to install the machine ☆When determining where to install the machine, consult well with customer. ☆Before installation, check the following. Danger ●Leave space between the wall. (If the wall has an inflammable structure) Warning ●Perform installation and other works in accordance with Building Standards Act, local regulations, Fire Service Act, “Standards and Practical Guidelines for Gas Appliances Installation”...
Page 3
※ As shown in the image below, if an inflammable material finished with non-inflammable coating, it is not considered as non-inflammable structure and separation distance from the wall must be secured. Even if the surface is non-inflammable, the internal structure may catch fire. If separation distance between the machine and the building cannot be secured, thicken the non-inflammable coating so the surface temperature of the inflammable material...
Page 4
Surroundings of the place where the machine is installed Warning ●Install the machine on a stable, hard and horizontal floor. ●Do not splash water onto the product. ●Do not place or use spray cans, or combustible, volatile or inflammable substance near the machine. ●Leave spaces so that the machine can be pulled out.
Page 5
Air supply/exhaust works Warning ●Perform installation and other works in accordance with Building Standards Act, local regulations, Fire Service Act, Gas Business Act, Liquefied Petroleum Gas Act, and “Standards and Practical Guidelines for Gas Appliances Installation”(Published by Japan Gas Appliances Inspection Association).
Page 6
Water supply/drain piping works Caution ●The connection part of Water supply piping must be connected securely to avoid water leakage. ・Please confirm there is no drops adhered etc. by water leakage after a trial. ●Water supply pressure must be used within the limits from 0.05 to 0.75MPa.
Page 7
Electrical works Danger ●Use the power source as indicated (phase, voltage and frequency). ●Do not turn on the main power (local switch) until the completion of works. Warning ●Electrical wiring works must be performed by a registered electrician. ●Electrical works must be in accordance with “Technical Standards for Electrical Equipment”, “Indoor Wiring Regulations”, and “Guidelines of Facility Design for Electrical Kitchen Facilities for Business Purpose”...
Need help?
Do you have a question about the MAZE-4 and is the answer not in the manual?
Questions and answers