Centsys Photon SMART Installation Manual

PHOTON SMART
INSTALLATION GUIDE
Centurion Systems (Pty) Ltd
www.centsys.com.au
1. Introduction
The Photon SMART infrared PE safety beams have been
designed to provide an integral element of safety to an
automated system while at the same time affording the
installer considerable freedom during the installation
process. Both the transmitter and recievers are
completely wireless – being powered via
two AA Alkaline batteries each – obviating the need for
tunnelling and digging for the purpose of running cables.
Not only does this arrangement allow for extremely easy
installation when it comes to mounting the beams, but it
dramatically reduces material and labour costs.
The Photon SMART PE safety beams are
only compatible with CENTSYS SMART
Controllers!
2. Safety Instructions
1. All installation, repair, and service work to this
product must be done by a suitably qualified
person.
2. Do not in any way modify the components of the
system.
3. Do not leave packing materials (plastic,
polystyrene, etc.) within reach of children as such
materials are potential sources of danger.
4. Dispose of all waste products like packing
materials, according to local regulations.
5. We do not accept any liability caused by improper
use of the product, or for use other than that for
which the product was intended.
6. This product was designed and built strictly for the
use indicated in this documentation. Any other use,
not expressly indicated here, could compromise the
service life/operation of the product and/or be a
source of danger.
7. Anything not expressly specified in these
instructions is not permitted.
INFRARED SAFETY BEAMS