LogiCO2 0475 Installation Instruction

Installation Instruction
0475 Enrichment Valve 10W
ENGLISH
Enrichment Valve with filter for Grow CO2
Enrichment Controller.
Important!
Retain this instruction manual for future
reference: Please read these instructions
carefully prior to start-up and use. Failure to
follow any of these instructions could void
product warranties. LogiCO2 assumes no
responsibility for claims arising out of improper
or careless use or handling of their products.
Technical specifications
Power supply:
Power consumption:
Relays:
Material:
Operating pressure:
Bursting pressure:
Treaded connection:
Dimensions (WxHxD)
Connection box:
Ingress protection:
Via Grow CO2 Enrichment
Controller
420 mA (10 Watt)
1A/24V AC/DC
PC/ABS
0,15 to 30 bar / 2,2 to 435 Psi
>150 bar / 2 175 Psi
1/4" -18NPT
78x78x37 mm / 3"x3"x1.5"
IP55
Function
Enrichment Valve is an accessory for LogiCO2 Grow
CO2 Enrichment Controller. The Grow CO2 Enrichment
Controller is a device that measures the concentration
of CO2 in the ambient environment of the room being
controlled and opens/closes the dispenser valve, to
achieve a perfect CO2 environment in the grow room.
Enrichment Valve consists of a magnetic valve with
filter, electronics box and cabling. The Enrichment
Valve is designed for usage of CO2 with a pressure of
0,15 to 30 bar or 2,2 to 435 Psi.
Enrichment Valve has a 1 meter Cat5 cable from
the electronics box, with a blue RJ45 connector that
is plugged in to the blue cable side of the Grow CO2
Enrichment Controller.
Install the electronics box in a suitable place where it is
mechanically protected. Remove the cover by turning
it counterclockwise 1/8 turn to access the mounting
screw holes.