Honeywell Farenhyt Series Product Installation Document page 2

2.1.2 Surface Mounting
The RA-100TR Red Trim Ring kit and RA-100TG Gray Trim Ring kit
are available for use when surface mounting the RA-2000/GRAY.
1. Remove the desired knockout.
2. Mark and pre-drill hole in the wall for the center top keyhole
mounting bolt. Refer to Figure 2 for mounting hole locations.
3. Install center top fastener in the wall with the screw head
protruding.
4. Place backbox over the top screw, level and secure.
5. Mark and drill the left and right upper and lower mounting holes.
6. Install remaining fasteners and tighten.
7. Run wires to the control panel. Refer to Figure 5.
8. Place the trim ring over the back box as shown below.
Figure 4 Installing Trim Ring
9. Attach the door assembly to the backbox using the screws
provided. Refer to Figure 3.
Honeywell Security & Fire
12 Clintonville Road
Northford, CT 06472-1610
203.484.7161
www.farenhyt.com
3 Wiring Connections
Wire the RA-2000/GRAY to the FACP as shown in below.
SBUS OUT
– + A
supervised,
power-limited,
Class B
151443 | D | 02-22
©2022 Honeywell International Inc.
remote annunciator
(back view)
ON
B
1
Figure 5 SBUS Connections
DIP Switches
2 3 4 5 6