Onkyo TX-SR505 Instruction Manual page 79

STANDBY/ON
STANDBY
MULTI CH DVD VCR/DVR CBL/SAT AUX
PHONES
A SPEAKERS B TONE STEREO LISTENING MODE
Positioning the SiriusConnect Home tuner
You can check the strength of the SIRIUS Satellite Radio
signal and adjust the position of the SiriusConnect Home
tuner accordingly.
1
On the AV receiver, press the
[SETUP] button.
SETUP
2
Use the TUNING Up and Down
[ ]/[
TUNING PRESET
Aiming," and then press
[ENTER].
ENTER
3
Adjust the position of the Sirius-
Connect Home tuner so that the
SAT signal strength bar is as
long as possible.
If you cannot receive a satellite signal,
press the Down [
the terrestrial (TER) signal strength
meter and adjust your antenna so that
the bar is as long as possible.
Terrestrial signals are only available in
certain areas.
So long as the signal strength is good,
you can enjoy SIRIUS Satellite Radio
by using either satellite or terrestrial
reception.
ENTER TUNING
MASTER VOLUME
TUNING PRESET
TAPE TUNER C D SETUP ENTER RETURN
AUX INPUT
SETUP MIC VIDEO L AUDIO R
DISPLAY DIGITAL INPUT DIMMER MEMORY TUNING MODE
CLEAR
SETUP
] buttons to select "ANT
] button to display
SIRIUS Satellite Radio Messages
The following messages may appear while using SIR-
IUS Satellite Radio.
❑ ACQUIRING
The SiriusConnect receiver is acquiring the signal or
no signal is present. Make sure the SiriusConnect
Home tuner is connected properly and that there are
no obstacles close by.
❑ ANTENNA ERROR
Make sure the SiriusConnect Home tuner is con-
nected properly.
❑ SUB UPDATED
Displayed while your subscription is being updated.
No operations can be performed until this message
has cleared.
❑ UPDATING XXX%
Displayed while the channel map is being updated.
Wait until the updating is complete.
❑ UPDATING
Displayed while the SiriusConnect receiver's firm-
ware is being updated.
❑ INVALID CHANNEL
Displayed if you select an unavailable channel.
❑ CALL SIRIUS
Displayed when you select a channel to which you
are not subscribed. Call SIRIUS if you want to sub-
scribe.
❑ CHECK SR TUNER
Displayed if the SiriusConnect receiver is not con-
nected. Make sure the SiriusConnect receiver is con-
nected properly, and make sure its AC adapter is
plugged in.
7