Advertisement
User's Manual
Foldable Access Ramps
63875
Illustration similar, may vary depending on model
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Illustrations, functional steps, and technical data may deviate insignificantly due to continuous further
developments.
Updating the documentation
If you have suggestions for improvement or have found any irregularities, please contact us.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for WilTec XPOtool 63875
Summary of Contents for WilTec XPOtool 63875
- Page 1 User’s Manual Foldable Access Ramps 63875 Illustration similar, may vary depending on model Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Illustrations, functional steps, and technical data may deviate insignificantly due to continuous further developments.
- Page 2 The information contained in this document may alter at any time without prior notice. No part of this document may be copied or otherwise duplicated without prior written consent. All rights reserved. WilTec Wildanger Technik GmbH cannot be held liable for any possible mistakes in this operating man- ual, nor in the diagrams and illustrations shown.
- Page 3 Introduction Thank you for choosing to purchase this quality product. To minimise the risk of injury, we ask you to always take some basic safety precautions when using this product. Please read this operating manual carefully and make sure that you understand it. Keep these operation instructions in a safe place.
- Page 4 • The ramps must not be used to support both ends at the same time or just one side of a vehicle as you would do with mounting stands. • The maximum wheel width is 9″. • Do not use other lifting devices in combination with these ramps. •...
- Page 5 Assembly Warning! Only assembly the device according to the illustrations. Do not assemble the device with the flange pointing upwards. The flange pointing downwards is meant to stabilise the ramp; it is not meant to guide the wheels. Right Notes •...
- Page 6 Step 3 To use the product for lorries, remove the stop inside the closed portion and install it to the end of the ramp as shown. Step 4 To use the product for ATVs/quads, remove the stop and open the 2 parts as shown. Secure the ramps to the loading area using the safety chains.
- Page 7 Always keep the surfaces of the ramps clean, dry, and free from oil and grease. Important Note: Reproduction and any commercial use (of parts) of this operating manual, requires a written permission of WilTec Wildanger Technik GmbH. https://www.XPOtool.com Item 63875...
Need help?
Do you have a question about the XPOtool 63875 and is the answer not in the manual?
Questions and answers