Advertisement
Advertisement
Table of Contents
Summary of Contents for Autogrow Folium F2
- Page 1 GETTING STARTED GUIDE...
- Page 2 This document will help you get started. If you need help at any time, get in touch with For more our support team: support@autogrow.com information visit: knowledge.autogrow.com Contents. Search: Folium Setting up your account...
- Page 3 From your PC or mobile device create an IntelliGrow account by following the link below. Or, if you already have an IntelliGrow account go to Step 2. https://intelligrow.autogrow.com/auth/register Folium sends your data to the IntelliGrow platform via a ‘gateway’ (supplied). The gateway is housed in weatherproof plastic box (also supplied).
- Page 4 Once the Time Zone has been updated the gateway configuration is complete and you can close the browser window. If you have any issues, please check our FAQ for troubleshooting, email the support team support@autogrow.com , or use the Livechat on our website.
- Page 5 Do not place in aisles, as the airflow will not represent typical conditions. • Suspend them slightly above the crop canopy immediately If you have an issues during the journey please don’t hesitate to adjacent to the plants. contact our support team – support@autogrow.com...
- Page 6 • Do not cover the top of the sensor: this will cause inaccurate light measurements. • Level the sensor. The wires attached to the top should suspend the sensor as close to level as reasonable. • Press the power button on the bottom of the Folium. The sensor will flash green for 3 seconds, indicating it’s powered and starting the self-test.
- Page 7 Knowledge.autogrow.com Search: Folium Or email support@autogrow.com ® AUTOGROW is a registered trade mark of Autogrow Systems Limited (Autogrow). ™ The Autogrow logos are trade marks of Autogrow. © 2020 Autogrow Systems Limited. All rights reserved. Issue 3 20201204...
Need help?
Do you have a question about the Folium F2 and is the answer not in the manual?
Questions and answers