Table of Contents
Advertisement
• The more refrigerant a refriger-
ator contains, the bigger its in-
stallation room should be. In
very small rooms, a flammable
gas-air mixture may occur in
case of a gas leak in the cool-
ing system. At least 1 m³ of
volume is required for each 8
grams of refrigerant. The
amount of the refrigerant avail-
able in your product is spe-
cified in the Type Label.
• The installation place of the
product shall not be exposed
to direct sunlight and it shall
not be in the vicinity of a heat
source such as stoves, radiat-
ors, etc. If you cannot prevent
installation of the product in
the vicinity of a heat source,
you shall use a suitable insula-
tion plate and the minimum
distance to the heat source
shall be as specified below.
– At least 30 cm away from
heat sources such as
stoves, heating units and
heaters, etc.,
– And at least 5 cm away from
electric ovens.
• Your product has the protec-
tion class of I.
• Plug the product in a groun-
ded socket that conforms with
the Voltage, Current and Fre-
quency values specified in the
type label. The socket must
have a 10A – 16A fuse. Our
firm will not assume respons-
ibility for any damages due to
usage without earthing and
power connection in compli-
ance with local and national
regulations.
• The product's power cable
must be unplugged during in-
stallation. Otherwise, risk of
electric shock and injury may
occur!
• Do not plug the product to
loose, broken, dirty, greasy
sockets or sockets that have
come out of their seats or
sockets with a risk of water
contact.
• Place the power cable and
hoses (if available) of the
product so that they shall not
cause a risk of tripping over.
• Penetration of humidity to live
parts or to the power cord
may cause short circuit. Thus,
do not use the product in hu-
mid environments or in areas
where water may splash (e.g.
garage, laundry room, etc.) If
EN / 6
Advertisement
Table of Contents
