TOOLS REQUIRED P en c i l Drill bi t ( 6、 3. 2) S i l i c o n e g u n F l a t a n d c r o s s T a p e m e a s u r e S p i r it l e v e l s c r e w d r i v e r R u b b e r h a m m e r...
Page 4
Drill holes and fit wall plugs if a solid Dry fit required for best position wall substitute for hollow wall fixings to connect wall profile. if necessary (not supplied). 6 mm Fit panel into wall profile. Screw wall profile A to wall with ST4*30 K screws.
Page 5
Drill guide holes into profile attached to glass panel with 3.2mm drill bit through existing holes in wall profile at chosen adjustment and secure with washer I and ST4*12 screws provided. Push screw cover profile B onto washers. 3 .2mm Choose required position for wall support bar.
Page 6
Cut bar C to correct length. Attach brackets D & E to bar ensuring D Separate wall bracket D and E into is in the correct position, and fix with component parts and attach to bar C screws supplied. with screws provided. Fit support bar wall bracket E in position required with ST4*30 screws provided.
Page 7
Fit wall profile corner caps Silicone as illustrated ensuring silicone G and F . sealant is on the outside only. Silicone as illustrated ensuring silicone sealant is on the outside only. ( 6)
Page 8
Cleaning & Maintenance Don’t clean the shower enclosure with irritant detergent such as alcohol,bleach or other chemical cleaners. Only clean with warm soapy water . Helpline:01452 317890 ( 7) S-277...
This manual is also suitable for:
Volente walk in58.61158.61258.61358.61458.615...
Show all