Advertisement
PRODUCT SPECIFICATIONS
Max. Label Width:
Max. Label Roll Weight: 8.5 lbs. (3.9 kg)
Max. Label Roll Size:
Speed:
Start/Stop:
Power Supply:
This product is for indoor use only.
Not for use in wet locations.
INITIAL SET-UP
1. Place the CSR30 with the Rewind Shaft perpendicular to the web of the
labels to be rewound, and near where the labels come out of the printer.
The CSR30 is bi-directional, so can be operated in either direction.
2. Verify that the (ON/OFF/ON Direction) Switch on the rear of the Unit is
in the OFF (0) position.
3. Set the VOLT CHANGE SW Slide Switch on the AC/DC Adapter to the
"4.5" position as an initial setting.
4. Insert the Power Cord into the Power Jack on the rear of the CSR30.
5. Plug the AC/DC Adapter into a suitable electrical outlet. It can be left
plugged in at all times.
6. The CSR30 has a combination Power and Direction (ON/OFF/ON
Direction) Switch on the Rear Panel. See photo below. The Center
Position of the Switch is "OFF" (0). To make the Rewinder run to the
right (looking from the rear of the Rewinder), press the Power / Direction
Switch in the direction of the right arrow. To make the Rewinder run to
the left, press the Power / Direction Switch in the direction of the left
arrow.
4.5 inches (115-mm)
Up to 8.5 inches (215-mm)
Adjustable up to 15-ips (380-mm/sec)
ON/OFF/ON Direction Switch
Voltage-selectable AC/DC Adapter 120vac 60Hz
UL & CSA Listed (230vac 50Hz available)
WARNING
Advertisement
