Advertisement
Quick Links
Advertisement
Summary of Contents for Tuindeco LILLBY S
- Page 1 INSTALLATION MANUAL "LILLBY S"...
- Page 2 Preparations · Sauna package must be stored in a heated and dry room. · Prior to installation ithe package must be opened and stored for 48h to adjust to relative humidity of the room (22 C, 40-60% RH). · Ensure the sauna model fits in the designated room with sufficient extra room for ease of installation.
- Page 3 1500 1356 1200 Light switch (black, 1-button) 1500 TECHNICAL INFORMATION SIZE WIDTH 1800 mm / DEPTH 1200 mm OUTSIDE HEIGHT (mm) 2100 mm INSIDE HEIGHT (mm) 2019 mm BASE FRAME WOODEN BASE FRAME 42x42 mm INSIDE WALL & CEILING VERTICAL STP 15X90 SPRUCE PROFILE OUTSIDE WALL VERTICAL STP 15x90 SPRUCE (A, C, D)
- Page 4 BASE FRAME Check substructure level. Sauna must be installed on a level surface. Connect the base frame elements Fix the elements with screws Check baseframe diagonals for equality and right corners Apply silicone under basefame and fix in place NOTE! If the sauna is to be moved after installation, silicone can be installed afterwards. Figure a.
- Page 5 VERTICAL WALL ELEMENTS See your technical drawing on next page Separate walls by letters Control wall symbols on base frame *Example picture...
- Page 6 VERTICAL WALL FIXING Start fixing walls from A-B corner Place walls on base frame Fasten screws from top Fix corners outside *Example picture...
- Page 7 VERTICAL WALL FIXING End assembly at front with D1, D2 and D3 elements. Place the elements on previously assembled and stable baseframe and fix with screws as indicated on Figure 2a, 2b (previous page). Continue with installation according to Figure 2a. Figure 2b.
- Page 8 CEILING ELEMENTS FIXING See your technical drawing on next page Start fixing from ceiling element 1 Pay attention to inside paneling Fix screws from top Use plywood blocks against paneling bend *Example picture...
- Page 9 HORIZONTAL BENCH SUPPORTS See your technical drawing on next page Measure right placement of supports Check level Fix screws *Example picture...
- Page 10 FIXING BENCH FRAMES Place bench frames on supports Control measures from cross-section drawing Level benches Fix side screws to tighten walls Fix back screws *Example picture...
- Page 11 FIXING BENCH GRIDS Place bench grids on bench frames Fix bench grids from below with screws *Fixing bench grids helps to prevent bench grid from bending *View from bottom *Example picture...
- Page 12 FIXING HEATER GUARD See your technical drawing on next page Control heights with your heater Fix heater guard to wall with screws *Example picture...
- Page 13 FIXING DOOR Remove glass from door frame Fasten frame Control angles Level frame Install glass *Example picture...
- Page 14 DOOR MOULDINGS Fix the inner and outer moldings with nails after door installation. Figure 9a. *Example picture...
- Page 15 Instructions for use and maintenance of pre-built and pre-assembled indoor and outdoor saunas 1. General installation requirements 1.1. Your sauna should be installed by a professional installer. 1.2. The installer of the sauna must have familiarised themselves thoroughly with the manufacturer's warranty terms and the installation instructions of the purchased sauna.
- Page 16 Instructions for use and maintenance of pre-built and pre-assembled indoor and outdoor saunas 5. Finishing/treating the wooden parts of the sauna with a protective agent 5.1.Before using the sauna, all wooden surfaces must be treated with a suitable protective agent. The manufacturer recommends using sauna wax or sauna oil (paraffin oil).
- Page 17 Instructions for use and maintenance of pre-built and pre-assembled indoor and outdoor saunas 8.2.Once a year or as needed: · Wash the horizontal (and, if necessary, vertical) surfaces of your sauna with a special sauna detergent. Use a soft brush or damp cloth and observe the instructions of the detergent. ·...
- Page 18 Warranty terms for saunas and sauna products Effective from 1.04.2022 definitions 1.1 "Manufacturer" is Auroom OÜ (registration code 14867010). "Product" means a sauna or sauna product (including a sauna bath, sauna door or sauna accessory) manufactured by the Manufacturer for indoor or outdoor use, whether prefabricated or assembled.
- Page 19 Warranty terms for saunas and sauna products Effective from 1.04.2022 The Warranty does not apply if: (a) the Customer has not notified the Seller or the Manufacturer within 2 months of becoming aware of the Defect; (b) the Seller has failed to notify the Manufacturer within 2 weeks of the time at which it became aware or should have become aware of the Defect;...
Need help?
Do you have a question about the LILLBY S and is the answer not in the manual?
Questions and answers