Command table
Available features differ by projector specification, input sources, settings, etc..
Commands are working if the standby power is 0.5W or a supported baud rate of the projector is set.
Uppercase, lowercase, and a mixture of both types of characters are accepted for a command.
If a command format is illegal, it will echo Illegal format.
If a command with correct format is not valid for the projector model, it will echo Unsupported item.
If a command with correct format cannot be executed under certain condition, it will echo Block item.
If RS232 control is performed via LAN, a command works whether it starts and ends with <CR>. All the commands and
behaviors are identical with the control through a serial port.
Function
Write Power On
Write Power off
Power
Read
Write COMPUTER/YPbPr
Write COMPUTER 2/YPbPr2
Source Selection
Write COMPUTER 3/YPbPr3
Write Component
Write Component2
Write DVI-A
Write DVI-D
Write HDMI(MHL)
Write HDMI 2(MHL2)
Write HDMI 3
Write Composite
Write S-Video
Write Network
Write USB Display
Write USB Reader
Write HDbaseT
Write DisplayPort
Write 3G-SDI
Type
Operation
Power Status
ASCII
<CR>*pow=on#<CR>
<CR>*pow=off#<CR>
<CR>*pow=?#<CR>
<CR>*sour=RGB#<CR>
<CR>*sour=RGB2#<CR>
<CR>*sour=RGB3#<CR>
<CR>*sour=ypbr#<CR>
<CR>*sour=ypbr2#<CR>
<CR>*sour=dviA#<CR>
<CR>*sour=dvid#<CR>
<CR>*sour=hdmi#<CR>
<CR>*sour=hdmi2#<CR>
<CR>*sour=hdmi3#<CR>
<CR>*sour=vid#<CR>
<CR>*sour=svid#<CR>
<CR>*sour=network#<CR>
<CR>*sour=usbdisplay#<CR>
<CR>*sour=usbreader#<CR>
<CR>*sour=hdbaset#<CR>
<CR>*sour=dp#<CR>
<CR>*sour=sdi#<CR>
8
LU951
YES
YES
YES
YES
NO
NO
NO
NO
NO
NO
YES
YES
YES
YES
YES
NO
NO
NO
YES
NO
NO