Advertisement
Quick Links
Operating Manual
Rain Sensor
Mini‐Clik II
PERROT
Bedie01e.doc
Rev. 03.02.2014
Page 1 / 4
Perrot REGNERBAU CALW GmbH Industriestraße 19‐29 / D‐75382 Althengstett / Germany
Phone: 0049‐7051‐162‐0 / Fax: 0049‐7051‐162–133
E‐mail: perrot@perrot.de / E‐mail Technical Department: technik@perrot.de
Advertisement
Summary of Contents for Perrot Mini-Clik II
- Page 1 Operating Manual Rain Sensor Mini‐Clik II PERROT Bedie01e.doc Rev. 03.02.2014 Page 1 / 4 Perrot REGNERBAU CALW GmbH Industriestraße 19‐29 / D‐75382 Althengstett / Germany Phone: 0049‐7051‐162‐0 / Fax: 0049‐7051‐162–133 E‐mail: perrot@perrot.de / E‐mail Technical Department: technik@perrot.de ...
- Page 2 Both wiring facilities are given at the controllers Water Control, Greenkeeper and Perrot Satellite. 2.2.1 Connection of Mini‐Clik at Perrot Controllers with (preferably) normally closed contact Use the following terminal connections: a.) Water Control Attach first wire at the first terminal of the controller designated as “sensor”. Attach second wire at the second terminal of the controller designated as “sensor”. b.) Perrot Satellite and Greenkeeper: Attach first wire at terminal no. 13 of the controller Attach second wire at terminal no. 14 of the controller Bedie01e.doc Rev. 03.02.2014 Page 2 / 4 Perrot REGNERBAU CALW GmbH Industriestraße 19‐29 / D‐75382 Althengstett / Germany Phone: 0049‐7051‐162‐0 / Fax: 0049‐7051‐162–133 ...
- Page 3 2.2.2 Connection of Mini‐Clik at the Perrot Controllers with a normally open contact a.) Water Control: Attach first wire at first terminal designated as “sensor” Attach second wire at second terminal designated as “sensor” b.) Perrot Satellite and Greenkeeper: Attach first wire at terminal no. 11 of the controller Attach second wire at terminal 12 of the controller Note: When installing the Greenkeeper and Perrot Satellite Controllers, the rain sensor has to be entered to the installation data of the computer programme (see operating manual Greenkeeper / Perrot Satellite). 2.2.3 Connection of the Mini‐Clik to other controllers: Prior to the connection please check whether the Mini‐Clik should be installed to a normally open or closed terminal ...
- Page 4 If the Mini‐Clik is exposed to rain fall, the hygroscopic discs will swell up and thus activate the contact to stop or respectively prevent from decontrolling the next scheduled irrigation cycle. The Mini‐Clik will reactivate the next programmed irrigation cycle after the discs have dried up by weather conditions (wind, sunlight, humidity, etc.). By turning the vent ring, the ventilation performance can be changed. This will influence the drying speed: biggest ventilation performance – maximum drying speed and vice versa (see figure no.2.) Thus, the Mini‐Clik offers the possibility to adjust the drying speed of the hygroscopic discs to the soil conditions at site. Experience will best determine the ideal ventilation setting. Reference values: for sandy permeable to water soils – adjust bigger ventilation performance. If the Mini‐Clik is installed at an overly sunny place – adjust a smaller ventilation performance. Figure 2 4. Benefits Mini‐Clik does not collect the rain fall but absorbs it by the hygroscopic discs. Thus the system has the following advantages: Measurement is not falsified by leaves, boughs or any other foreign particles No frost damages by collected water Decontrol of the next scheduled irrigation cycle is controlled and automatically activated Subject to change without prior notice. Please do not hesitate to contact for any additional information. Bedie01e.doc Rev. 03.02.2014 Page 4 / 4 Perrot REGNERBAU CALW GmbH Industriestraße 19‐29 / D‐75382 Althengstett / Germany Phone: 0049‐7051‐162‐0 / Fax: 0049‐7051‐162–133 E‐mail: perrot@perrot.de / E‐mail Technical Department: technik@perrot.de ...