Page 1
Operating Instructions Grade 80 Weld on Hook with latch Note: The Operator must read and fully understand the operating instructions before using this product. ...
● The use of a latch may be mandatory by regulations or safety codes; e.g., OSHA, MSHA, ANSI/ASME B30, Insurance, etc. ● Ensure latch functions properly. Use only genuine GT replacement parts. ● Never attach more than one sling directly in hook. For collecting two or more slings to the hook, use proper hardware.
Page 3
WARNING! ● Loads may disengage from hook if proper procedures are not followed. ● A falling load may cause serious injury or death. ● Hook must always support the load. The load must never be supported by the latch. ● Never apply more force than the hook’s assigned Working Load Limit (WLL) rating. ●...
Page 4
For welding hook to other grades of steel, a qualified weld procedure must be developed. GT hook material is AISI 8622 modified. ● Welding is to be performed by a qualified welder using qualified procedure in accordance with American Welding Society (AWS), and/or American Society of Mechanical Engineers (ASME) requirements.
Page 5
● Welding should be carried out completely around base in a minimum of two passes to ensure adequate root penetration at the base of the hook. ● Do not rapidly cool the weld. ● After welding, a visual inspection of the weld should be performed prior to painting. ●...
Page 6
Step 2A Step 3 - Hook Sizes 4 to 10 tonnes 2A. Spread legs of spring and place into drilled 3. Position latch over spring, aligning latch ears and spring coil. On pin hole side of latch, insert non grooved hole.
SPECIFICATIONS & DIMENSIONS Product Code Model No. B C E L W.L.L. B.L. Weight kgs / mm mm mm mm t t each G80WH1 SLR0191.0T 78 90 23.5 98 1 5 0.485 G80WH2 SLR0192.0T 92 81 ...
Page 8
George Taylor & Co Lifting Gear (Midlands) Limited Unit 4, Fryers Road, Walsall, West Midlands WS2 7LZ T + 44 (0)1922 490220 F + 44 (0)1922 490229 E o ffice@gtlifting.co.uk www.gtlifting.co.uk...