Panasonic ET-LAB50 Replacement Instructions page 3

Lamp unit replacement procedure
Check that the area around
1
the lamp unit has cooled
down.
Use a Phillips screwdriver
2
to turn the lamp unit cover
fixing screws at the bottom
of the projector, and then
remove the lamp unit cover.
Lamp unit cover
Lamp unit cover fixing screws
Use a Phillips screwdriver
3
to loosen the two lamp unit
fixing screws until the screws
turn freely. Then hold the
handles of the lamp unit and
gently pull the lamp unit out
from the projector.
Handles
Ⓐ
Lamp unit fixing screws
Ⓑ
Insert the new lamp unit
4
while making sure that
the direction of insertion
is correct, and then use
a Phillips screwdriver to
securely tighten the lamp
unit fixing screws.
• When inserting the new lamp
unit, be sure to push it in at
the point Ⓐ and Ⓑ .
Install the lamp unit cover,
5
and then use a Phillips
screwdriver to securely
tighten the lamp unit cover
fixing screws.
NOTE:
• Be sure to install the lamp unit and the
lamp unit cover securely.
Connect the mains lead.
6
Press the POWER button so
7
that a picture is projected
onto the screen.
NOTE:
• If "DIRECT POWER ON" in the
"OPTION" menu has been set to "ON",
projection will start after the mains lead
is connected.
E -3
NGLISH