Millennium KONTI Quick Start Manual

GENERIC INSTRUCTIONS FOR INSTALLATION OF
MILLENNIUM BATH FILLERS & BATH FILLERS WITH
HAND SHOWERS ON CONCRETE FLOORS
KONTI/AKEMI/CIOSO/KIATO
BATH FILLERS & BATH FILLERS
WITH HAND SHOWER
Important Information
• Hot and cold water inlet pressures should be equal.
• Maximum static water pressure is 500kpa - AS/NZS3500.1-2003(clause 3.3.4).
If water pressure exceeds 500kpa warranty is voided.
• Lines must be flushed out prior to installation of the mixer. Damage caused to the
mixer by copper filings/foreign matter coming through the pipework is not covered
under warranty.
• Maximum hot water temperature is 80C.
Cleaning Instructions
1. Under no circumstances should tapware be installed using acetone silicone
2. Never clean Mixers/Tapware/Showers/Accessories using harsh detergents/cleaning
products, citrus based cleaning products or abrasive cleaning pastes.
3. Where your tapware remains dry in use, a soft 100% cotton cloth can be used to remove
dust
4. Alternatively, wipe over with a soft 100% cotton cloth using tepid water with a small
amount of liquid soap added (2% liquid soap maximum). Using a different cotton cloth
thoroughly rinse off all soap mix using cold water. To finish wipe off all residual water with
another dry cotton cloth