Fora TN'G Scale 550 Mobile Operating Instructions page 3

Once a stable value is obtained, the reading will flash
three times and then calculate your BMI.
4. Understanding your displayed result.
1 2 1 2 6
3
4
5
Personal Profile Number Weight Unit
1 5
Gender: Male BMI Symbol
2 6
Volume Your BMI
3 7
Your Weight
4
5. Step off the weighing platform.
The result is saved in the scale memory and the scale enters into 4G connection
mode.
6. The 4G signal indicator will flash when it is in
transmission mode. The three bars indicate the
quality of the 4G signal:
- 1 bar: weak
- 3 bars: good
When the bars are solid (not flashing), it means that
the 4G transmission is established. The scale will
turn off automatically when data transmission is
complete, or left idle after 3 minutes.
Poor signal quality may affect the data transfer process. If the signal quality is poor,
move the scale to a spot with better reception and try again. Make sure the scale is not
close to or nearby a microwave, mobile devices, or any other devices that may
interrupt the signal.
SCALE MEMORY
Your scale stores up to a 135 measurements for all 5 personal profiles. Results in
memory can be transmitted to the mobile device by 4G connection. This allows you to
review your measurements on your mobile device.
MAINTENANCE
Your scale uses one 3.7V Lithium-ion rechargeable battery
Low Battery Signal
The scale will display the message shown to alert you
when the scale power is running low. This means it is
about time to charge the battery of the scale.
Recharging the Battery
The USB adapter with a USB Type-C cable can be used when you need to recharge the
Li-ion battery. To recharge the 3.7V Li-ion battery, please follow the procedures below:
Connect USB adapter to the scale
1. Connect the USB adapter and USB Type-C cable to the scale.
2. Plug the USB adapter into an electrical outlet. The battery indication light should
turn red / orange.
Remove USB adapter from the scale
1. When the battery indication light turns green, it means that the battery is fully
charged. Remove the USB adapter from the electrical outlet.
2. Disconnect the USB Type-C cable from the scale.
WARNING!
• TD-2555G can ONLY use one 3.7V Lithium-ion rechargeable battery.
• Installing wrong types of batteries may cause explosions.
• USB adapter is not included in the kit, please make sure you have a USB adapter before
charging.
Cleaning
● To clean the outside of the scale, wipe it with a slightly damped cloth and water or a
mild cleaning agent, and then dry the device with a soft dry cloth. Do NOT immerse
the device in water.
● Do NOT use chemical or organic solvents to clean the scale.
● Wipe the scale clean at once if any grease, sauce, vinegar, juice or other
3
substances that may cause damage are spilled on the scale.
Scale Storage
7
● Storage condition: -13°F to 158°F (-25°C to 70°C), 10% to 93% relative humidity.
● Avoid dropping the scale or heavy impact.
● Avoid direct sunlight and high levels of humidity.
SYSTEM TROUBLESHOOTING
Error Messages
MESSAGE WHAT IT MEANS
The weighing subject exceeds Remove the weighing subject
the maximum capacity of the from the platform to avoid
device. damage.
If you follow the recommended action but the problem persists, or if error messages
other than the ones shown above appear, please contact local customer service. Do
not attempt to repair the device by yourself and do not try to disassemble the scale
under any circumstances.
SYMBOL INFORMATION
SYMBOL REFERENT SYMBOL
Manufacturer
Serial number
SPECIFICATIONS
General Information
Model No. : TD-2555G
Power Source : One 3.7V Lithium-ion rechargeable battery
Dimensions & Weight : 340 (L) x 400 mm (W) x 32 mm (H), 3300g
Size of LCD : 98 (L) x 92 (W) (mm)
LCD : Backlit LCD
Range :
Gender: Male / Female
Height: 3' 3.5" to 7' 2.5" / 100 to 220 cm
Age: 6 to 99
Weight: 8.8 to 550 lb / 4 to 250 kg
Operating Conditions : 41°F to 104°F (5 °C to 40 °C), 15% to 85% R.H.
Storage Conditions : -13°F to 158°F (-25°C to 70°C), 10% to 93% R.H.
Battery Life :
At least 180 measurements (3 minutes each time) or at least 3 months on standby.
Power Supply Input: DC +5V/2A via Type-C cable
Accuracy:
4.0 to 60.0 kg ±0.3kg
60.1 to 250.0kg ±0.5%
User Profile : 5 individuals
Weight Unit : lb / kg
Transmission : 4G
Operating Altitude: Up to 2000m, for indoor use.
Degree of Pollution: Pollution degree 2
Auto Switch-Off:
1. If the meter is idle for 30 seconds during the measuring mode, it will switch off
automatically.
2. If the meter is idle for 3 minutes during the 4G transmission mode, it will switch off
automatically.
This device has been tested to meet the electrical and safety requirements of: IEC/EN
61010-1, IEC/EN 61326-1, EN 301 489-17.
FEDERAL COMMUNICATIONS COMMISSION (FCC) STATEMENT
15.21
You are cautioned that changes or modifications not expressly approved by the part
responsible for compliance could void the user's authority to operate the
equipment.
15.105(b)
Federal Communications Commission (FCC) Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
● Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
WHAT TO DO
1. This device may not cause harmful interference and
2. This device must accept any interference received, including interference that may
cause undesired operation of the device.
FCC RF Radiation Exposure Statement:
1. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
2. For portable operation, this device has been tested and meets FCC RF exposure
guidelines. When used with an accessory that contains metal may not ensure
compliance with FCC RF exposure guidelines.
REFERENT
Caution
Taidoc Technology Corporation
B1-7F, No. 127, Wugong 2nd Rd., Wugu Dist., 24888 New Taipei City, Taiwan
www.taidoc.com
Read instructions before use.