T300 Hg120 Electronic Card; Power Supply And Safety Instructions; 1-Power Supply - Makim T300 HG120 Installation And User Manual

Kullanım Kılavuzu
10

5.1 T300 HG120 ELECTRONIC CARD

5.2 POWER SUPPLY AND SAFETY INSTRUCTION

5.2.1-POWER SUPPLY:

Control equipment and electronic control unit on the hiddengate are fed.with 100W/ 24V 4.5A
single output ,closed type Power Supply. Power supply is capable of feding existing hardware.
5.2.2-POWER SUPPLY SAFETY INSTRUCTIONS
1.Never take off the safety cover on the power supply.
2.While making any arrangements, take into consideration
all the warnings on the safety cover and power supply and
fuse rating.
3.The label on the power supply shows the edges where the
connections will be made. You should abide by the signs on
the label while making connections..
NOTE: DO NEVER FEED EXTERNAL DEVICES FROM THE
CONTROL CARD OR POWER SUPPLY OF THE
HIDDENGATE. MANUFACTURER DOES NOT ACCEPT ANY
RESPONSIBILITY FOR THE FAILURES CAUSED BY THIS.
Makim Makine Teknolojileri A.Ş. All rights reserved .