TABLE OF CONTENTS SYSTEM OVERVIEW..........................3 ELECTRONICS............................3 GAS VALVE AND PILOT COMPONENTS ....................3 GAS REQUIREMENTS..........................4 IGNITION CONTROL SPECIFICATIONS ....................4 INSTALLATION............................5 PROPER VENTING..........................8 ACCEPTABLE MEDIA..........................8 OPERATION............................8 MAINTENANCE ............................9 HELPFUL TIPS FOR PROPER OPERATION..................10 12V SYSTEM CLEARANCE FROM COMBUSTIBLES ................14 TROUBLESHOOTING .......................... 15 PARTS LIST &...
VIEW The Smart Weather Electronic Ignition System utilizes CSA certied components to be added to an outdoor product. Installation must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1 / NFPA, or International Fuel Gas Code. The appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, with the National Electric Code, ANSI/NFPA 70, if applicable.
GAS REQUIREMENTS FUEL TYPE GAS PRESSURE REQUIREMENTS Prior to making gas connections, ensure appliance being installed is compatible with the available Pressure Natural Gas Propane Gas gas type. Check the label on the appliance to conrm appliance gas type requirement. Minimum 3.5”...
INSTALLATION STARTUP WARNING: Inspect all components beore installation. A small amount of air will be in the gas supply lines. When I any parts are damaged contact your supplier. DO NOT INSTALL DAMAGED PARTS. rst lighting appliance it will take a short time or air to purge from lines.
Page 6
MUST READ! BURNING MEDIA INSTALLTION WARNING: I the inormation in this manual is not ollowed exactly, a re or explosion may result causing property damage, personal injury, or loss o lie. WARNING: Placement o media (glass, lava, stone, etc.) MUST cover pilot assembly.
Page 7
GAS CONNECTION Installation or repair should be perormed by a qualied The SWEIS box may now be mounted to the burner or service technician who is locally licensed. The appliance burner & pan combination. Thread sealant must be should be inspected before use and at least annually by used on all pipe thread connections.
PROPER VENTING OPERATION WARNING: HOT - DO NOT TOUCH - MAY RESULT IN WARNING: Venting is required to dissipate heat and SEVERE BURNS any residual uel. Failure to provide proper ventilation - Supervise children in same area as the appliance. could result in overheating and or explosion.
MAINTENANCE PRIOR TO EACH USE WARNING: Maintenance should only be perormed Inspect or debris in re eature – remove debris prior by a qualied service technician. The appliance should to use. be inspected beore use and at least annually by a SEMI-ANNUALLY qualied service technician.
HELPFUL TIPS FOR PROPER OPERATION Cross ventilation is REQUIRED! A minimum o 1 square inch o ventilation is required or every 25,000 BTUs on each side o the installation. Air ow is your riend! Media (lava rock and glass) minimum o 1/2" and no larger than 2" in diameter. Media must not cover the pilot.
TROUBLESHOOTING THE SWEIS IS INSTALLED BUT WHEN TURNED ON Electrical Current: NOTHING HAPPENS: I purging the gas line does not solve the problem, The most common cause is an electrical wiring the ignition failure is most likely that the igniter is or power issue.
Page 17
TROUBLESHOOTING GUIDE SEQUENCE OF FAULT CHECK RESULT ACTION(S) OPERATION Check or 14V at No or low Make sure transormer is powered. I so, replace Transformer voltage transformer. Check wiring or continuity, replace i broken. No Function / No LED Power ON Indication Check or 14V at No or low...
PARTS LIST & ACCESSORIES 24" PILOT IGNITER PILOT IGNITER PILOT IGNITER ASSEMBLY COVER GLOW PLUG TOP-500PIR TOP-PIC TOP-PIGP MINI & STANDARD CAPACITY UNITS TOP-500PIRHC HIGH CAPACITY UNITS BLUETOOTH PILOT TRANSFORMER CONTROLLER ORIFICE(S) TOP-PI23 | #23 ORIFICE OPT-12V TOP-500BLU MINI CAPACITY UNITS TOP-PI30 | #30 ORIFICE STANDARD &...